(3) Setting the Synchro Recording Level
★ This sets the synchro recording start level when synchro recording is used.
(See Page 18.)
★ When using synchro recording, recording will start when the level of the input signal exceeds a set value. Recording will stop
when the signal continues to be at level that is lower than the set value for 10 seconds or longer.
1
Set the unit to the setup mode, then turn the jog dial of the main unit or press the automatic search button of the
remote control to display “Sync. Level?”.
2
Press the enter button and set the synchro recording selection mode.
3
Turn the jog dial of the main unit or press the automatic search button of the remote control, then set the synchro
recording level.
• The setup value is displayed in the multiple display area. “Sync. -**dB”
✽ The setting range is from –54 dB to –30 dB, variable in 6 dB steps.
4
Press the enter button and set the synchro recording level.
•“Complete” will be displayed.
(Main unit) (Remote control unit)
(4) Setting of the Auto Track Mark (ATM)
★ Refer to page 6 for a description of the Auto Track function.
1
Set the unit to the setup mode, then turn the jog dial of the main unit or press the automatic search button of the
remote control to display “A.T. Mark?”.
2
Press the enter button and set the auto track mark selection mode.
3
Turn the jog dial of the main unit or press the automatic search button of the remote control to select auto track mark
on or off.
• The selected mode indication will flash. “On/Off”
4
Press the enter button and set the auto track mark on or off.
•“A.T.Mark On” or “A.T.Mark Off” will be displayed.
(Main unit) (Remote control unit)
(5) Fade-in time setting
★ To perform fade-in recording, set the fade-in time.
(See Page 19.)
1
Set the unit to the setup mode, then turn the jog dial of the main unit or press the automatic search button of the
remote control to display “FadeIn Time?”.
2
Press the enter button to set the fade-in time setting mode.
3
Turn the jog dial on the main unit or use the automatic search buttons on the remote control unit to set the fade-in time.
• The setting is displayed on the multi-display section. “FadeIn **sec”
✽ The setting can be set between 1 and 15 seconds in steps of 1 second.
4
Press the enter button to set the fade-in recording time.
•“Complete” will be displayed.
(6) Fade-out time setting
★ To perform fade-out recording, set the fade-out time.
(See Page 19.)
1
Set the unit to the setup mode, then turn the jog dial of the main unit or press the automatic search button of the
remote control to display “FadeOutTime?”.
2
Press the enter button to set the fade-out time setting mode.
3
Turn the jog dial on the main unit or use the automatic search buttons on the remote control unit to set the fade-out
time.
• The setting is displayed on the multi-display section. “FadeOut**sec”
✽ The setting can be set between 1 and 15 seconds in steps of 1 second.
4
Press the enter button to set the fade-out recording time.
•“Complete” will be displayed.