![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/0/75/0756dd51-4caf-4578-a394-39f73d289774/0756dd51-4caf-4578-a394-39f73d289774-bg2a.png)
39
ENGLISH
Basic versionSimple version InformationAdvanced version
Playback in ZONE2 (Separate room)
• You can operate this unit so as to enjoy audio in a different room
(ZONE2) other than the MAIN ZONE (room where the unit is located).
• You can simultaneously play back the same source in both the MAIN
ZONE and ZONE2. You can also play back separate sources in the
MAIN ZONE and ZONE2.
• There are two methods to do this, as described below. Choose one
of the methods.
q ZONE2 playback by speaker output
wZONE2 playback by audio output (using an external amplifier)
q ZONE2 playback by speaker
output
The ZONE2 audio signals are output from this unit’s SURR.BACK/AMP
ASSIGN speaker terminals using the amplifier assignment function.
Connecting and setting the speakers
“Amp Assign” setting
(vpage54) and audio
signals output
Connecting the speakers
ZONE2
Output signal :
Stereo (L / R)
MAIN ZONE
ZONE2
This unit
w ZONE2 playback by audio output
The audio signals connected to this unit’s ZONE2 output terminals
(ZONE2 OUT) are output to the ZONE2’s amplifier and played with
that amplifier.
Connection (ZONE2)
R
L
R
L
AUX
IN
This unit
MAIN ZONE
ZONE2
• Adjust the volume on the connected amplifier.
• We recommend using high quality pin-plug cables for audio
connections in order to prevent noise.
• Also be sure to read the operating instructions of the connected
devices.
NOTE
It is not possible to play the digital audio signals input from the
HDMI, COAXIAL or OPTICAL terminals in ZONE2. Play using analog
connections (in stereo).
Playback
1
Switch ZONE SELECT to “ZONE2”.
The remote control unit switches to the
operating mode for ZONE2.
Input source
select buttons
2
Press AMP.
3
Press ZONE/DEVICE ON to turn
on the ZONE2 power.
The indicator on the display lights.
• Also, pressing any of input source select
button in standby mode turns on the power.
• When
ZONE/DEVICE OFF is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
pressing ZONE2 ON/OFF on the main unit.
4
Press the input source select button.
The audio signal of the selected source is output to ZONE2.
• Turn
SOURCE SELECT after
pressing ZONE2 SELECT on
the main unit to select an input
source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select “MAIN” in step 1 then
press ZONE/DEVICE OFF.