11
RISK OF ELECTRIC
SHOCK
CAUTION
The lighting flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert user to
the presence of uninsulated
"dangerous voltage" within
the product's enclosure
that may be of sufficient
magnitude to constitute
risk of electric shock
to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE
COVER (OR BACK). NO
USER - SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CAUTION
For Compact Disc Units Only:
INVISBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED
OR DEFEATED. AVOID DIRECT EXPORSURE TO LASER BEAM.
1 In CD mode with a CD inserted and play stopped,
press the MEMORY button one time.
2 Select a track you would like to program by using
the FORWARD or BACKWARD skip buttons.
3 Once you have selected a track, press the
MEMORY button once more. That track is now
stored in the memory.
4 You can program up to 16 tracks in the memory.
Repeat steps 1 - 3 to program selected tracks.
5 When all desired tracks are programmed, press
the PLAY/PAUSE button to start playback. The
programmed tracks will play in the order in which
they were programmed.
6 To clear the programming, press the MEMORY
button one time and then press the STOP button
one time. This will clear the programming. The
programming will also be cleared if the CD
drawer is opened, the power is turned off, or if
the radio is unplugged.
CD Player & Connecting Optional Equipment
Optional External Speakers
1 With your new radio, you have the option of
adding external speakers.
2 The speaker jacks for external speakers are
located on the back of the radio. Along with the
speaker jacks is a switch labeled int./ ext. When
using external speakers, this switch must be
switched to the ext. position. Doing this turns off
the internal speakers in the radio and redirects
the power to the external speakers.
3 If you decide not to use the external speakers,
be sure the switch is on int. or the internal
speakers will not work.
Programming Your CD Player
Specification
Frequency Range : AM 520 - 1710 KHz
: FM 87.9 - 108.9 MHz
Power Consumption : 18 Watts
Antennas : External FM antenna
: Built-in ferrite AM bar
Power Source : AC 120V / 60 Hz
Speaker : 4” Dynamic type X 2
Speaker Wattage : 5 Watts
Speaker ohms : 4 ohms
Output ohms : 4 ohms
Output Wattage : 2 Watts per channel
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
TRACK
Program input mode
MEMORY
TRACK
MEMORY
Choose track 4
TRACK
MEMORY
Program input complete
The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.
