Installation Instructions JSB2090
5
ASSEMBLY AND INSTALLATION
NOTE: The following procedure assumes that a Chief TS218
swing arm mount (not included) has already been
installed following instructions included with the mount.
1. Hook two clips (C) over top of display, with long edge of clip
on back of display. (See Figure 1)
Figure 1
2. Slide interface bracket (A) up from bottom along back of
display, ensuring that bottom of interface bracket hooks
over square extension on back of display. (See Figure 2)
3. Hang interface bracket onto studs at bottom of clips (C).
(See Figure 2)
Figure 2
4. Fasten interface bracket to clips using four 1/4-20 locknuts
(F). (See Figure 2)
5. Attach display to swing arm by lining up and inserting four
studs on interface bracket (A) into holes in swing arm. (See
Figure 3)
IMPORTANT ! : If attaching to the Chief TS318 swing
arm, use four .750x.344x.500 spacers (G) on the mount
studs before attaching the mount to the swing arm face.
6. Fasten display to swing arm using four 10-24 locknuts (E).
(See Figure 3)
Figure 3
7. Lift shelf assembly (B) up from below display and hook onto
interface bracket (A). (See Figure 4)
Figure 4
1
(C)
1
Back of
display
4
(F) x 4
2
(A)
(C)
Hook over
extension
bracket
Extension
bracket
6
(E) x 4
5
(Swing arm not shown for clarity)
7
(B)
(Display with
attached
interface
bracket)
Hook shelf
assembly
