Filter
Top Products
Function Key/Action/LED Signal
Normally, you can connect every Bluetooth cell phone to the headset. However,
depending on the phone type, some functions cannot be operated through the headset.
This includes the automatic music rendering after a call, redialing, or other functions.
Therefore, if you have problems with your mobile phone, please consult the phone’s
owner’s manual.
Automatic and manual call acceptance
1). The headsets offer you the possibility to choose between automatic and manual
call acceptance. Factory settings will be “automatic” call acceptance.
2). To change to manual call acceptance, activate channel 1 and press the [T] key for
5 seconds. If you want to change it to automatic again, press the [T] key again for
5 seconds. You will also hear a sound signal in your headset.
3). If the automatic call acceptance in activated, you will hear the ringing of the
phone in your headset which will be automatically activated after 2-3 rings. To
hang up the phone, momentarily press the [T] key.
4). If the manual call acceptance is activated, you will have to accept the call by
pressing the [T] key during the call. To hang up the phone, you have to
momentarily press the [T] key again.
Basic Functions and Operation Pairing to a Cell Phone
17
Activate channel 1
Activate channel 2
4 Tones
4 Tones
4 Tones
4 Tones
5 Tones
4 Tones
-----------
-----------
-----------
-----------
-----------
-----------
4 Tones
1 Tone
Deactivate channel 1
Deactivate channel 2
Pairing
Connected
Redialing
Stand-by
Microphone sensitivity
Press the [-’] key for 4 seconds until the red LED flashes.
Press the [-] key for 3 seconds until the red LED flashes longer then
release.
Press the [+] key for 3 seconds until the green LED flashes longer
then release.
1 Flash per second
3 flashes per second
Press mute key for 5 seconds
Briefly press/release the [T] key.
Manual: Press [T] key when hearing the call signal.
Press the [+] key from power off status until the green LED starts flashing
rapidly.
Press the [+] key for 3 seconds until the green LED flashes. If the
headsets haven’t been paired before, the headset go into SLAVE
mode and starts flashing rapidly.
Press [-] & [+] simultaneously from power off status for 6 seconds and release.
low = 4 flashes
middle = 2 flashes
high = 1 long flash
Accept call
Stop/Play music
Press mute key momentarily
Start/Stop intercom
Interval sounds every 30 seconds
iPress [R] key when the headset is turned on;.All LEDs turn off.
Low battery status
Reset