Filter
Top Products
11
CHANGING A DOORBELL’S SETTINGS
214601 C - IMAGE 13
1. BE SURE THE GREEN POWER LIGHT
IS OFF (IF THE LIGHT IS ON, WAIT ABOUT
2 MINUTES)
2. USE AN OBJECT TO PRESS AND HOLD
THE PROGRAM BUTTON UNTIL A BEEP
SOUNDS
3. RELEASE THE PROGRAM BUTTON
(BE READY TO COUNT BEEPS)
4. THE DOORBELL WILL BEEP, COUNTING
THE EXISTING HOUSE CODE NUMBER
PROGRAM
BUTTON
INSIDE HOLE
B
A
1. PRESS THE TALK BUTTON
1 TO 15 TIMES TO SET THE
NEW HOUSE CODE NUMBER
2. THE DOORBELL WILL BEEP,
COUNTING THE NEW HOUSE
CODE NUMBER
PLACE THE DOORBELL INTO PROGRAM MODE
AND COUNT THE EXISTING HOUSE CODE NUMBER BEEPS
SET THE DOORBELL'S NEW HOUSE CODE NUMBER
3
1
TO CHANGE A DOORBELL
OR ADD A NEW DOORBELL
3. PRESS THE PROGRAM
BUTTON TO EXIT
PROGRAM MODE
5
4
2
NOTE: UNITS ARE PRE-SET AT THE FACTORY
WITH THE SAME HOUSE CODE, CHANGING
THE HOUSE CODE IS ONLY NECESSARY
WHEN ADDING ADDITIONAL UNITS OR TO
AVOID OVERLAP WITH OTHER SYSTEMS
THE FACTORY SETTING FOR THE FREQUENCY
SWITCH IS "A", SET THE FREQUENCY SWITCH
TO MATCH THE CONSOLE (EITHER "A" OR "B")
THE FACTORY SETTING FOR THE STATION SWITCH
IS "5", SET THE STATION SWITCH TO EITHER "4" OR "5"
CHIME SOUND:
5 = "DING-DONG"
4 = "DONG"
DOORBELL BEEPS THE
EXISTING HOUSE CODE
NUMBER
DOORBELL BEEPS THE
NEW HOUSE CODE
NUMBER
NOTE: ALL UNITS MUST BE SET TO
THE SAME HOUSE CODE NUMBER
FACTORY SETTING:
HOUSE CODE = 10