VTech VT 9123 Cordless Telephone User Manual


 
26
FCC Part 68
The FCC requires that you connect your cordless telephone to the nationwide telephone
network through a modular telephone jack (USOC RJ11C, RJ11W or RJ14).
Your telephone company may discontinue your service if your equipment causes harm to the
telephone network. They will notify you in advance of disconnection, if possible. During
notification, you will be informed of your right to file a complaint with the FCC.
Occasionally, your telephone company may make changes in its facilities, equipment, opera-
tion, or procedures that could affect the operation of your equipment. If so, you will be given
advance notice of the change to give you an opportunity to maintain uninterrupted service.
The Base Unit contains no user serviceable parts. The Handset contains a user replaceable
battery pack.
If it is determined that your telephone equipment is malfunctioning, the FCC requires that it not
be used and that it be unplugged from the modular jack until the problem has been corrected.
Repairs to this telephone equipment can only be made by the manufacturer or its authorized
agents or by others who may be authorized by the FCC. For repair procedures, follow the
instructions outlined under the Limited Warranty.
This equipment may not be used on coin service provided by the phone company or Party
Lines.
The REN is useful in determining the number of devices you may connect to your telephone
line and still enable the devices to ring when you receive a call. The general rule is that the
REN value should not exceed 5.0 total; however, contact your local telephone company for
the specific number in your area.
IC (Industry Canada)
This telephone is registered for use in Canada.
Notice: The Ringer Equivalence Number(REN) assigned to each terminal device denotes
the percentage of the total load to be connected to a telephone loop which is used by the
device, to prevent overloading. The termination of a loop may consist of any combination of
devices subject only to the requirement that the sum of the Ringer Equivalent Numbers of all
devices not exceed 5.0.
Notice: The Industry Canada label identifies certified equipment. This certification means
that the equipment meets certain telecommunications network protective, operational and
safety requirements. The Department does not guarantee the equipment will operate to the
user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to
the facilities of the local telecommunications company. The equipment must also be installed
using an acceptable method of connection. The customer should be aware that compliance
with the above conditions may not prevent degradation of services in some situations.
FCC & IC REGULATIONS
ADDITIONAL INFORMATION