Filter
Top Products
5
REPLACING THE HANDSET BATTERIES
GETTING STARTED
1. Slide the battery cover off by gently
pressing on the recessed area with
a downward motion.
2. Unplug and remove the old battery
pack. Don't put the old battery pack
in a trash compactor or a fire - it
could burst.
3. Plug in the replacement battery
pack. Place the battery pack in the
compartment with the battery cord
resting on top of it.
4. Replace the battery cover by
sliding it into place.
5. The new battery pack must be
charged before using your
telephone. Place the handset in the
cradle of the base unit to allow it to
charge for 16 hours.
CAUTION: To reduce the risk of fire or injury, read and follow these instructions:
1. Use only VTECH battery pack.
2. Do not open or mutilate the battery. Released electrolyte is corrosive and may cause
damage to the eyes or skin. It may be toxic if swallowed.
3. Exercise care in handling batteries in order not to short the battery with conducting
materials such as rings, bracelets, and keys. The battery or conductor may overheat and
cause burns.
4. Do not dispose of the battery in a fire. The cell may explode.
Recharging the Battery Pack
Your
VT 9152
provides both audible and visual alerts when the battery pack is low and
requires charging. Return the Handset to the Base cradle when:
1. The IN USE/LOW BATT LED is slowly flashing; and/or
2. You hear a
double beep
while you’re on a call or when you press PHONE/FLASH to make
or answer a call.
When fully charged, you will experience up to 5 hours of continuous talk, or up to 6 days of
standby (off the cradle, but not in use).