Filter
Top Products
20
BASIC OPERATION
FLASH
You can use your VTech VT1901
cordless phone with services such as
Call Waiting. Simply press the FLASH
key.
REDIAL
To REDIAL the last number you
dialed, press the PHONE key, then
press REDIAL . The phone will
automatically dial the number.
HOLD
Press HOLD to place an active call
on hold.
The PHONE LED will flash to indicate
call is on hold.
Press HOLD again to return to
the call.
MUTE
Press MUTE to disable the handset
microphone.
The MUTE/LO BATT LED will stay on
continuously.
Press MUTE again to return to two
way conversation.
RINGER MUTE
Press MUTE during incoming ringing
to disable the ringer for the duration of
the call.
PAGE
To page from the base, press
PAGE .
To cancel the page, either press
PAGE again on the base or press
OFF on the handset.
ANSWERING CALLS
When the Handset is in the Base Unit
cradle, simply pick up the Handset to
answer an incoming call.
When the Handset is away from the
Base Unit press any key other than
OFF , MUTE or the Volume keys to
answer an incoming call.
MAKING CALLS
1. Press the PHONE key and wait
for a dial tone.
2. Then dial the number you want.
If you make a mistake when dialing,
press OFF to hang up, then press the
PHONE key to get the dial tone again.
DISCONNECTING
To end a call, either place the handset
back in the Base Unit, or press OFF
.
EXTENSION IN USE INDICATOR
When another phone is in use on the
same line, and the VTech VT1901 is
in standby mode, the PHONE LED will
flash slowly.
Extension In Use indication will not
function when the Handset is out of
range.
VOLUME CONTROLS
The volume controls for the handset
are located on the side of the unit.
Press the or keys to increase
or decrease the volume. Holding either
key down will continuously change the
volume setting. The earpiece volume
level will change accordingly. There
are four volume levels.
1901MANUAL 1/28/99, 3:29 PM20