Filter
Top Products
Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). If necessary, place the handset in the telephone base
or charger to charge the battery. For best performance, keep the handset in
the telephone base or charger when not in use. The battery is fully charged
after 16 hours of continuous charging. See the table on page 9 for battery
operating times.
If the screen is blank or shows Place in charger, you need to charge the
handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. When the battery is low,
the handset shows Low battery and a ashing icon. If you are on a call in
low battery mode, the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank
or shows Place in
charger and ashes.
Battery has very little or
no charge. The handset
cannot be used.
Charge without interruption (at
least 30 minutes).
The screen shows
Low battery and
ashes.
Battery has enough
charge to be used for a
short time.
Charge
without interruption
(about 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
If you do not plug in the battery into the handset and place it in the telephone base
or charger, the screen displays No battery.
3