Filter
Top Products
Getting Started
Registration
Your IP 811 is an accessory handsets for use with the IP 8100-2/8100-3 base unit. To
register your IP 811 for the first time:
1. After charging the battery, the screen will display:
7
SEARCHING...
E N T E R B A S E
HANDSET X
2. Enter the 15 digit base unit ID code, located on
the underside of your
IP 8100-2/8100-3 base.
If you make a mistake, press the DELETE key
to backspace (delete characters), then enter the
correct information.
3. Press
SEL to complete the registration process.
4. Once a valid base ID code has been entered, the
display will blank for a second or two, and
then
show:
5. If the base accepts the new handset, after several
seconds the new handset will show:
Where X is the new handset number
assigned,sequentially, by the base.
NOTE: If any of the digits are entered incorrectly press the DELETE key
to erase a character(s) and carefully re-enter the correct base ID code. If
you have entered any digits incorrectly you will hear an error tone after the
SEL key is pressed. The 15-digit base ID code may contain numbers and
characters, including 0 through 9 and *. Make sure you enter all 15 digits.
811.vcan.om.eng.indd 7 10/27/05 11:16:27 AM