Filter
Top Products
6
Setup
Follow the steps below:
1. Remove the battery compartment
cover by pressing on the indent and
sliding downward.
2. Place the new battery pack in the
Handset with the metal contacts
aligned with the charge contacts in
the battery compartment.
3. Replace the battery compartment
cover by sliding it upwards.
4. Place the Handset in the charger, and
allow to charge for at least 12 hours.
5. Please note that the first charging after
prolonged storage may yield a lower
capacity than normal. However, capacity
will be restored after 2 to 3 charging/
discharging cycles.
6. After the first charge, a maintenance
charge of 8 hours will be sufficient.
Connecting Power to Handset Charger
Because the VT5801 is an accessory Handset to the VT 5836 or VT5886, all
you need to do is choose the location for your Handset Charger, and plug in the
power supply into an electrical outlet.
Installation and charging of Battery Pack in Handset
Getting Started
91-5628-10-00_5801 HK En manualBackup.p65 2/17/2004, 12:08 PM6