Filter
Top Products
www.vtechphones.com
29
Advanced operation
Answering system operation
Set telephone base ringer
This feature allows you to select the telephone base ringer volume levels. You can choose from HI
(high), OF (off) or LO (low).
To change the setting:
Press SET UP in idle mode until the system announces the telephone base ringer setting.
Press /SKIP or /REPEAT until the system announces the desired telephone base ringer volume
level, then press SET UP to save the setting and go to the next setting or press /PLAY/STOP
to save and exit set up mode.
Set remote access code
A two-digit security code is required to access the answering system remotely from any touch tone
telephone. The code preset at the factory is 19. You can set the code from 10 to 99.
To set the remote access code:
Press SET UP when in idle mode until the system announces the remote access code setting.
Press /SKIP or /REPEAT to change the remote access code by one, or press and hold /SKIP
or /REPEAT to change it by increments of ten.
Press SET UP to save the setting and go to the
next setting, or press /PLAY/STOP to save and exit set up mode.
Set message alert tone
This feature programs the system to beep every 10 seconds to alert you of new messages. The
beeping will stop when all new messages have been reviewed.
To set the message alert tone:
Press SET UP when in idle mode until the system announces the message alert tone setting.
Press /SKIP or /REPEAT to alternate between on or off, then press SET UP to save the setting,
and go to the next setting or press /PLAY/STOP to save and exit set up mode.
1.
2.
1.
2.
1.
2.
• The answering
system must be
turned on for the
message alert tone
to function.