Filter
Top Products
9
Call screening at the telephone base
If the answering system and call screening are on, the announcement and the
incoming message broadcast at the telephone base when a call is answered by
the answering system.
Options while recording a message:
Press VOL or VOL on the telephone base to adjust the call screening volume
.
Press /PLAY/STOP to temporarily turn on or off call screening.
Press VOL to temporarily turn on call screening when it is set to off.
Call intercept
If you want to talk to the person whose message is being recorded, press or
on the handset.
Add and register a handset
The handsets provided with your telephone system are already registered. Each
handset is assigned a number that displays on the handset. Additional handsets
registered to the telephone system are assigned numbers in the sequential order.
This telephone system accommodates up to five handsets.
You can add new handsets (CS6409, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased and properly charged, each expansion handset shows
1.PRESS FIND HS ON BASE 4 SEC and 2.THEN PRESS # ON HANDSET
alternately. Charge the handset before registering it to the telephone base.
To register a handset:
Place the non-registered handset in the telephone base or charger.
On the telephone base, press and hold /FIND HANDSET for about
four seconds until the red IN USE light turns on.
On the handset, press # (pound key) then the handset shows REGISTERING.....
PLEASE WAIT. Then the handset shows HANDSET REGISTERED and you
hear a beep when the registration process completes. The registration process
takes about 60 seconds to complete.
Replace a handset
If you want to replace a handset or reassign the designated handset number of a
registered handset, you must deregister all handsets and then individually register
each handset.
To deregister all handsets:
Press and hold /FIND HANDSET on the telephone base for about 10 seconds
until the IN USE light on the telephone base turns on and starts flashing.
Press and release /FIND HANDSET again. You must press /FIND HANDSET
while the IN USE light is still flashing. The IN USE light flashes for approximately
five seconds.
All handsets show 1.PRESS FIND HS ON BASE 4 SEC and
2.THEN PRESS # ON HANDSET alternately when the deregistration process
completes. The deregistration process takes about 10 seconds to complete.
Rewiring of telephone line for cable/VoIP service users
If you have changed to cable/VoIP service through a modem/router/terminal
adapter to establish telephone connection, the existing telephone jacks in your
home may no longer work. Your cable/VoIP service provider uses a separate cable
connecting from the main line to the modem installed in your home.
To allow all existing telephone jacks to work, rewiring of the telephone line (as
indicated by the dotted line in the illustration below) may be needed. Rewiring
requires professional installation (fees may apply). Contact your cable/VoIP
service provider for more information.
•
•
•
1.
2.
3.
1.
2.
3.
OLD
Conventional
telephone line jack
Main
landline
NEW
Modem/Router/
Terminal adapter
Main cable
line