VTech CS6428-2 Cordless Telephone User Manual


 
2
Telephone base and charger installation
Install the telephone base and charger as shown below.
Telephone line cord
Telephone base
Charger
Telephone base
power adapter
A DSL filter (not included)
is required if you have DSL
high-speed Internet service
Electrical outlet
not controlled
by a wall switch
Electrical outlet
not controlled
by a wall switch
Telephone wall jack
Charger adapter
Use only the power adapter and battery supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call 1 (800) 595-9511.
In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.
The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into
a ceiling, under-the-table or cabinet outlet.
If you subscribe to telephone service from a cable company or a VoIP service
provider, plug the telephone line cord into the modem/router/terminal adapter
provided by your cable/VoIP service provider. Contact your cable/VoIP service
provider if you have any difficulties in installation.
Battery installation
Install the battery as shown below.
Slide the battery compartment
cover towards the center of the
handset until it clicks into place.
3. Place the handset in the telephone
base or charger to charge.
4.
Plug the battery connector
securely into the socket.
1. Place the battery with the label
THIS SIDE UP facing up and the wires
inside the battery compartment.
2.
If the handset will not be used for a long time, disconnect and remove the battery to
prevent possible leakage.
CHARGE light
remains on
when charging.
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation
is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone
line may need to be rewired to allow all existing telephone jacks to work. Refer
to Rewiring of telephone line for cable/VoIP service users on page 9 for
more information.