Filter
Top Products
3
Battery charging
Once you have installed the battery, the screen indicates the
battery status (see the table below). If necessary, place the
handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the telephone base or
charger when not in use. The battery is fully charged after
10 hours of continuous charging. See the table on page 8 for
battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 30 minutes to give the handset enough
charge to use the telephone for a short time. When the battery is
low, the handset plays four short beeps and shows LOW BATTERY
along with a flashing icon. When you are on a call in low battery
mode, the handset plays four short beeps every 50 seconds.
The following table summarizes the battery charge indicators and
actions to take.
Getting started
Battery indicators Battery status Action
The screen is blank,
or shows
PLACE IN CHARGER
and flashes.
Battery has no
charge or very
little charge. The
handset cannot
be used.
Charge without
interruption (at least
30 minutes).
The screen shows
LOW BATTERY and
flashes.
Battery has
enough charge to
be used for a
short time.
Charge without
interruption (at least
30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
If you place the handset in the telephone base or charger without
plugging in a battery, the screen displays NO BATTERY.
After you install your telephone or power
returns following a power outage, the handset
will prompt you to set the date and time. To skip
setting the date and time, press OFF/CANCEL.
SET DATE
--/--/--