Filter
Top Products
Battery charging
Once you have installed the battery, the screen indicates the
battery status (see the table below). If necessary, place the
handset in the telephone base or charger to charge the
battery. For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully
charged after 16 hours of continuous charging. See the table
on page 8 for battery operating times.
If the screen is blank, you need to charge the handset without
interruption for at least 10 minutes to give the handset enough
charge to use the telephone for a short time. When the battery
is low, the handset beeps four times every minute, shows
LOW BATTERY and a ashing icon. If you are on a call
in low battery mode, the handset has four short beeps to
alert you.
The following table summarizes the battery charge indicators
and actions to take.
Battery indicators Battery status Action
The screen is blank. Battery has no
charge and the
handset cannot be
used.
Charge without
interruption (at least
10 minutes).
The screen shows
PLACE IN CHARGER
and ashes.
Battery has very
little charge and
the handset cannot
be used.
Charge without
interruption (at least
four minutes).
The screen shows
LOW BATTERY and
ashes. The handset
beeps four times every
minute.
Battery has enough
charge to be used
for a short time.
Charge
without
interruption
until
the screen shows
HANDSET X (about
30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery
charged, place it in
the telephone base
or charger when not
in use.
If you do not plug in the battery into the handset and place it in the
telephone base or charger, the screen displays NO BATTERY.
Getting started
3