Filter
Top Products
MAINTENANCE
FCC AND IC REGULATIONS
This equipment complies with Parts 15 and 68
of the Federal Communications Commission
(FCC) rules for the United States. It also
complies with regulations RSS-210 and CS-
03 of Industry Canada (IC).
A label is located on the underside of the base
unit containing either the FCC registration
number and Ringer Equivalence Number
(REN) or the IC registration number and Load
Number. You must, upon request, provide this
information to your local telephone company.
This equipment is compatible with inductively
coupled hearing aids.
FCC Part 15
Warning:Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
The equipment has been tested and found to
comply with part 15 of the FCC rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try and correct the interference
by one or more of the following measures:
WARRANTY STATEMENT
TAKING CARE OF YOUR TELEPHONE
Your
VT 9116
cordless telephone
contains sophisticated electronic parts so
it must be treated with care.
AVOID ROUGH TREATMENT
Place the handset down gently. Save the
original packing materials to protect your
telephone if you ever need to ship it.
AVOID WATER
Your telephone can be damaged if it gets
wet. Do not use the handset outdoors in
the rain, or handle it with wet hands. Do
not install your base unit near a sink,
bathtub or shower.
Remember that electrical appliances can
cause serious injury if used when you
are wet or standing in water. If your base
unit should fall into water,
DO NOT
RETRIEVE IT UNTIL YOU UNPLUG THE
POWER CORD AND TELEPHONE LINE
CORDS FROM THE WALL
. Then pull the
unit out by the unplugged cords.
ELECTRICAL STORMS
Electrical storms can sometimes cause
power surges harmful to electronic
equipment.
For your own safety, use caution when
using electric appliances during storms.
CLEANING YOUR TELEPNONE
Your telephone has a durable plastic
casing that should retain its luster for
many years. Clean it only with a soft cloth
slightly dampened with water or a mild
soap. Do not use excess water or
cleaning solvents of any kind.
WHAT DOES OUR WARRANTY COVER?
* Any defect in material or workmanship.
FOR HOW LONG AFTER THE ORIGINAL PURCHASE?
* One Year.
WHAT WILL VTECH DO?
* At our option, repair or replace your unit.
HOW DO I SEND MY UNIT, IN OR OUT OF WARRANTY?
* Call VTECH Communications customer service for Return Authorization at:
1-800-595-9511
* Properly pack your unit. Include any cables & accessories which were originally provided
with the product. We recommend using the original carton and packing materials.
* Include in the package a copy of the sales receipt or other evidence of date of original
purchase (if the unit was purchased within the last twelve months.)
* Print your name and address, along with a description of the defect, and include this in
the package.
* Include payment for any service or repair not covered by the warranty, as determined by
VTECH Communications.
* In the US, ship the unit via UPS Insured, or equivalent to:
VTECH COMMUNICATIONS
11035 SW 11th Street
Bldg. B Suite 270
Beaverton, OR 97005
VTECH Communications assumes no responsibility for units sent without prior Return Authorization.
WHAT DOES OUR WARRANTY NOT COVER?
* Batteries
* Damage from misuse, neglect, or acts of nature (lightning, floods, power surges. etc.)
* Products which may have been modified or incorporated into other products
* Products purchased outside the USA
* Products serviced by the owner or a service facility not expressly authorized by VTECH
Communications
* Products purchased more than 12 months from current date
HOW DOES STATE LAW RELATE TO THIS WARRANTY?
* This warranty gives you specific rights. You may also have other rights which vary from
state to state.
IF YOU PURCHASED YOUR TELEPHONE IN CANADA
Please call: 1-800-267-7377
Ship to: VTECH ELECTRONICS
200-7671 ALDERBRIDGE WAY
RICHMOND, BC V6X 1Z9
IC (Industry Canada)
This telephone is registered for use in
Canada.
Notice:The Industry Canada label
identifies certified equipment. This
certification means that the
equipment meets certain
telecommunications network,
protective, operational and safety
requirements. Industry Canada
does not guarantee the
equipment will operate to the
user’s satisfaction.
Before installing this equipment, users
should ensure that it is permissible to be
connected to the facilities of the local
telecommunications company.The
equipment must also be installed using an
acceptable method of connections. The
customer should be aware that compliance
with the above conditions may not prevent
degradation of service in situations.
Repairs to certified equipment should be
made by an authorized Canadian
maintenance facility designated by the
supplier. Any repairs or alterations made
by the user to this equipment, or equipment
malfunctions, may give the
telecommunications company cause to
request the user to disconnect the
equipment.
Users should ensure for their own
protection that the electrical ground
connections of the power utility, telephone
lines and internal metallic water pipe
system, if present, are connected together.
FCC AND IC REGULATIONS
* Reorient or relocate the receiving antenna.
* Increase the separation between the
equipment and receiver.
* Connect the equipment into an outlet or on a
circuit different from that to which the receiver
is connected.
* Consult the dealer or an experienced radio/
TV technician for help.
FCC Part 68
The FCC requires that you connect your
cordless telephone to the nationwide telephone
network through a modular telephone jack
(USOC RJ11C or RJ11W).
Your telephone company may discontinue your
service if your equipment causes harm to the
telephone network. They will notify you in
advance of disconnection, if possible. During
notification, you will be informed of your right to
file a complaint with the FCC.
If it is determined that your telephone equipment
is malfunctioning, the FCC requires that it not be
used and that it be unplugged from the modular
jack until the problem has been corrected.
Repairs to this telephone equipment can only
be made by the manufacturer or its authorized
agents or by others who may be authorized by
the FCC. For repair procedures, follow the
instructions outlined under the VTECH Limited
Warranty.
The REN is useful in determining the number of
devices you may connect to your telephone line
and still enable the devices to ring when you
receive a call. The general rule is that the REN
value should not exceed 5.0 total; however,
contact your local telephone company for the
specific number in your area.
This precaution may be particularly
important in rural areas.
Caution:Users should not attempt to
make such connections
themselves, but should contact
appropriate electric inspection
authority, or electrician, as
appropriate.
Notice: The REN assigned to this device
denotes the number of devices
you may connect to the
telephone loop,whice is used by
the device to prevent verloading.
The termination on a loop may
consist of any combination
devices subjected only to the
requirement that the sum of the
REN does not exceed five.(5.0)
This device complies with RSS-210 of
Industry Canada. Operation is subject to
the following two conditions: (1) this device
may not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
FREQUENCY CONTROL
Crystal Controlled Dual PLL Synthesizer
TRANSMIT FREQUENCY
Handset: 923.10MHz to 927.75 MHz
Base: 902.30 MHz to 906.65MHz
RECEIVE FREQUENCY
Handset: 902.30 MHz to 906.65MHz
Base: 923.10MHz to 927.75 MHz
NOMINAL EFFECTIVE RANGE
Maximum power allowed by FCC and IC.
Actual operating range may vary according
to environmental conditions at the time of use.
SIZE
Handset: 20.8cm x 5.9cm x 4.3cm
(L x W xT) maximum
(antenna excluded)
Base: 19.3cm x 13.8cm x 6.2cm
(L x W x T) maximum
(antenna excluded)
WEIGHT
Handset: 180grams
Base: 205grams
POWER REQUIREMENTS
Handset: Self-contained nickel-
cadmium rechargeable
battery supply, 3.6V
nominal, 400mAh capacity.
Power Adapter: 9V DC @ 200mA
SPECIFICATIONS ARE TYPICAL AND MAY
CHANGE WITHOUT NOTICE.
FCC AND IC REGULATIONS
12
13
14
15
TECHNICAL
SPECIFICAT
IONS