Filter
Top Products
What does this limited warranty
cover?
• The manufacturer of this VTech
product, VTech Communica-
tions, warrants to the holder of
a valid proof of purchase
(“Consumer” or “you”) that the
product and all accessories
provided by VTech in the sales
package (“Product”) are free
from material defects in material
and workmanship, pursuant to
the following terms and conditions,
when installed and used normally
and in accordance with operation
instructions. This limited warranty
extends only to the Consumer for
Products purchased and used in
the United States of America.
What will VTech Communica-
tions do if the Product is not
free from material defects in
materials and workmanship
during the limited warranty
period (“Materially Defective
Product”)?
• During the limited warranty period,
VTech authorized service
representative will repair or
replace at VTech option, without
charge, a Materially Defective
Product. If we repair this product,
we may use new or refurbished
replacement parts. If we choose
to replace this product, we may
replace it with a new or refurbished
product of the same or similar
design.VTech will return repaired
or replacement products to you
in working condition. VTech will
retain defective parts, modules,
4. Product to the extent that the
problem is caused by use with
non-VTech electrical accesso-
ries; or
5. Product whose warranty/quality
stickers, Product serial numbers
plates or electronic serial numbers
have been removed, altered or
rendered illegible; or
6. Product purchased, used,
serviced, or shipped for repair
from outside the United States, or
used for commercial or institutional
purposes (including but not limited
to Products used for rental
purposes); or
7. Product returned without valid
proof of purchase (see 2 below);
or
8. Charges for installation or set up,
adjustment of customer controls,
and installation or repair of
systems outside the unit.
How do you get warranty
service?
• To obtain warranty service in the
United States of America, call 1-
800-595-9511 for instructions
regarding where to return the
Product. Before calling for service,
please check the user’s manual.
A check of the Product controls
and features may save you a
service call.
• Except as provided by applicable
law, you assume the risk of loss
or damage during transit and
transportation and are responsible
for delivery or handling charges
incurred in the transport of
Product(s) to the service location.
Warranty Statement
or equipment. Repair or
replacement of Product, at VTech
option, is your exclusive remedy.
You should expect the repair or
replacement to take approximately
30 days.
How long is the limited warranty
period ?
• The limited warranty period for the
product extends for ONE(1)YEAR
from the date of purchase if we
repair or replace a Materially
Defective Product under the terms
of this limited warranty. This
limited warranty also applies to
repaired or replacement Products
for a period of either (a) 90 days
from the date the repaired or
replacement Product is shipped to
you or (b) the time remaining on
the original one-year warranty;
whichever is longer.
What is not covered by this
limited warranty ?
This limited warranty does not cover.
1. Product that has been subjected
to misuse, accident, shipping or
other physical damage, improper
installation, abnormal operation or
handling, neglect, inundation, fire,
water or other liquid intrusion; or
2. Product that has been damaged
due to repair, alteration or
modification by anyone other
than an authorized service
representative of VTech; or
3. Product to the extent that the
problem experienced is caused
by signal conditions, network
reliability or cable or antenna
systems; or
Warranty Statement
12
13
VTech will return repaired or
replaced product under this limited
warranty to you, transportation,
delivery or handling charges
prepaid .VTech assumes no risk
for damage or loss of the Product
in transit.
• If the Product failure is not
covered by this limited warranty,
or proof of purchase does not
meet the terms of this limited
warranty, VTech will notify you
and will request that you authorize
the cost of repair prior to any
further repair activity. You must
pay for the cost of repair and
return shipping costs for the
repair of Products that are not
covered by this limited warranty.
What must you return with the
Product to get warranty
service?
1. Return the entire original package
and contents including the Product
to the VTech service location
along with a description of the
malfunction or difficulty;
2. Include alid proof of purchase”
(sales receipt) identifying the
Product purchased (Product
model) and the date of purchase
or receipt; and
3. Provide your name, complete and
correct mailing address, and
telephone number.
Other Limitations
• This warranty is the complete and
exclusive agreement between you
and VTech. It supersedes all
other written or oral communi-
14
Warranty Statement
Technical
Specifications
cations related to this Product.
VTech provides no other
warranties for this product. The
warranty exclusively describes
all of VTech responsibilities
regarding the product. There are
no other express warranties. No
one is authorized to make
modifications to this limited
warranty and you should not rely
on any such modification.
State Law Rights: This warranty
gives you specific legal rights,
and you may also have other
rights which vary from state to
state.
Limitations: Implied warranties,
including those of fitness for a
particular purpose and
merchantability (an unwritten
warranty that the product is fit for
ordinary use) are limited to one
year from date of purchase.
Some states do not allow limitations
on how long an implied warranty
lasts, so the above limitation may
not apply to you.
• In no event shall VTech be liable
for any indirect, special, incidental,
consequential, or similar damages
(including, but not limited to lost
profits or revenue, inability to use
the product, or other associated
equipment, the cost of substitute
equipment, and claims by third
parties) resulting from the use of
this product. Some states do not
allow the exclusion or limitation of
incidental or consequential
damages, so the above limitation
or exclusion may not apply to
you.
Your 2101 cordless telephone contains
sophisticated electronic parts so it
must be treated with care.
Avoid rough treatment
Place the handset down gently. Save
the original packing materials to
protect your telephone if you ever
need to ship it.
Avoid Water
Your telephone can be damaged if it
gets wet. Do not use the handset
outdoors in the rain, or handle it with
wet hands. Do not install your base
unit near a sink, bathtub or shower.
Electrical Storms
Electrical storms can sometimes
cause power surges harmful to
electronic equipment.
For your own safety, use caution
when using electric appliances during
storms.
Cleaning your telephone
Your telephone has a durable plastic
casing that should retain its luster for
many years. Clean it only with a soft
cloth slightly dampened with water or
a mild soap. Do not use excess water
or cleaning solvents of any kind.
Remember that electrical appliances
can cause serious injury if used when
you are wet or standing in water. If
your base unit should fall into water,
DO NOT RETRIEVE IT UNTIL YOU
UNPLUG THE POWER CORD AND
TELEPHONE LINE CORDS FROM
THE WALL. Then pull the unit out by
the unplugged cords.
FREQUENCY CONTROL
Crystal controlled dual PLL
Synthesizer
TRANSMIT FREQUENCY
Handset: 923.40 MHz to 927.75
MHz
Base: 902.40 MHz to 907.05
MHz
RECEIVE FREQUENCY
Handset: 902.40MHz to 907.05
MHz
Base: 923.40 MHz to 927.75
MHz
NOMINAL EFFECTIVE RAN-
GE
Maximum power allowed by FCC and
IC. Actual operating range may vary
according to environmental conditions
at the time of use.
SIZE
Handset: 16.1cm x 5.3cm x 3.9cm
(L x W xT) maximum
(antenna excluded)
Base: 11.5cm x 9.1cm x 9.5cm
(L x W x T) maximum
(antenna excluded)
WEIGHT
Handset: 158 grams
Base: 129 grams
POWER REQUIREMENTS
Handset: Self-contained nickel-
cadmium rechargeable
battery supply, 3.6V
nominal, 300mAh capacity.
Power Adapter: 6V AC @ 220mA
15
SPECIFICATIONS ARE
TYPICAL AND MAY CHANGE
WITHOUT NOTICE.
This equipment complies with Parts
15 of the Federal Communications
Commission (FCC) rules for the
United States. It also complies with
regulations RSS210 and CS-03 of
Industry and Science Canada.
Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
A label is located on the underside
of the Base Unit containing either the
FCC registration number and Ringer
Equivalence Number (REN) or the
IC registration number and Load
Number. You must, upon request,
provide this information to your local
telephone company.
This equipment is compatible with
inductively coupled hearing aids.
Should you experience trouble with
this telephone equipment, please
contact:
VTech Communications Inc.
Customer Service at 1-800-595-
9511. In Canada, call VTech
Telecommunications Canada
Ltd. at 1-800-267-7377
.
For repair/warranty information. The
telephone company may ask you to
disconnect this equipment from the
line network until the problem has
been corrected.
FCC Part 15
Warning: Changes or modifica-
tions to this unit not expressly
approved by the party responsible
for compliance could void the
user's authority to operate the
equipment.
The equipment has been tested and
found to comply with part 15 of the
FCC rules. These limits are designed
to provide reasonable protection
against harmful interference in a
residential installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try and
correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet or on a circuit different
from that to which the receiver
is connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
FCC Part 68 and ACTA
information
If this equipment was approved for
connection to the telephone network
prior to July 23, 2001, it complies with
Part 68 of the Federal Communications
Commission (FCC) rules. If the
equipment was approved after that
date, it complies with the Part 68 rules
and with Technical Requirements for
Connection of Equipment to the
Telephone Network adopted by the
Administrative Council for Terminal
Attachments (ACTA). We are required
to provide you with the following
information.
1. Product identifier and REN
information
The label on the back or bottom
of this equipment contains,
among other things, an identifier
indicating product approval and
the Ringer Equivalence Number
(REN). This information must
be provided to your local
telephone company upon
request. For equipment
approved prior to July 23, 2001,
the product identifier is preceded
by the phrase “FCC Reg No.”
and the REN is listed separately.
For equipment approved after
that date, the product identifier
is preceded by “US” and a
colon (:), and the REN is
encoded in the product identifier
without a decimal point as the
sixth and seventh characters
following the colon. For example,
the product identifier US:
AAAEQ03T123XYZ would
indicate an REN of 0.3. T h e
REN is used to determine how
many devices you may connect
to your telephone line and still
have them ring when you are
called. In most, but not all areas,
the sum of all RENs should be
five (5.0) or less. You may want
to contact your local telephone
company for more information.
2. Connection and use with
the nationwide telephone
network
The plug and jack used to
connect this equipment to the
premises wiring and the
telephone network must comply
with the applicable Part 68 rules
and technical requirements
adopted by ACTA. A compliant
telephone cord and modular plug
is provided with this product. It
is designed to be connected to
a compatible modular jack that
is also compliant. An RJ11 jack
should normally be used for
connecting to a single line and
an RJ14 jack for two lines. See
Installation Instructions in the
user manual. This equipment
may not be used with Coin
Telephone Lines or with Party
Lines. If you have specially
wired alarm dialing equipment
connected to your telephone
line, ensure the connection of
this equipment does not disable
your alarm equipment. If you
have questions about what will
FCC, ACTA and IC Regulations
Maintenance
16
17
FCC, ACTA and IC Regulations
t2101Eng.p65 2004/12/29, ¤W¤È 10:543