Valcom V-2901 Answering Machine User Manual


 
2 947301
Power Requirements
Voltage: 115VAC
or 24VDC Battery Backup
Power: 25 watts
Environment
Temperature: 0 to 50 Degrees C
Humidity: 0-85% non-precipitating
DESIGN
General
The V-2901 Remote Door Answering System when
used with the V-1070A Door Plate Speaker provides
voice paging with handsfree reply to a door. When
the push-button on the door plate speaker is pressed,
the phone system will ring. By answering the call, the
system user can converse with the person at the door.
If the door is equipped with an electric strike plate,
the system user may allow access by dialing a code or
pressing a button.
Electronic Key, 1A2 Key or
PABX Access
When using the V-2901 with an electronic key system
or PABX, the following equipment will be required:
1) 1 V-2901 Universal Door Answering Unit
2) 1 C.O. Line Position (Electronic Key System
or
1 Loop Trunk Position (PABX)
1 400 type line card (1A2 key)
3) 1 Valcom V-1070A or V-1071 Door Plate
Speaker
Dedicated Single Line Phone Access
When using the V-2901 with a single line telephone,
the following equipment will be required:
1) 1 V-2901 Universal Door Answering Unit
2) 1 Single Line Tone Dial Telephone dedicated
for door answer
3) 1 Valcom Door Plate Speaker (V-1070A or
V-1071))
NOTE: A single line telephone cannot be connected
to both the V-2901 and an incoming central office
line.
INSTALLATION
Connecting Arrangement
If a modular cord is used for Tip and Ring
connections, start at step ONE. For screw terminal
connections start at step TWO.
__1. Connect one end of a modular cord to the
V-2901 RJ11 and the other end to the
appropriate line position of the phone
system. Go to step 4.
__2. Connect Tip of the key system line position
(loop trunk) to Tip terminal of the V-2901.
__3. Connect Ring of the key system (loop trunk)
to the Ring terminal of the V-2901.
__4. Connect Tip and Ring of the V-1070A Door
Plate Speaker to V-2901 screw terminals
marked SPKR.
__5. Connect Door Button terminals of V-1070A
to V-2901 screw terminals marked DPB.
__6. Turn slide switch SW1 ON if the telephone
system is to ring when the door plate button
is pressed.
V-2901
UNIVERSAL
DOOR
ANSWER
UNIT
E-Key
C. O. Line Position
Speaker
Pushbutton
Door Plate Speaker
Assembly
FIGURE 1 - TYPICAL E-KEY INSTALLATION