Filter
Top Products
Telephone’s Analogue Adapter – UTStarcom iAN-02EX (V1.8.2.17a) – Operating Manual pag.12
CONFIGURATION PARAMETERS OF UTStarcom IAN-02EX ATA EQUIPMENT
Access parameters to the equipment:
IP address: verify on ADSL modem
User name: supervisor
Password: Assigned by Eutelia
LAN/WAN PARAMETERS
WAN Configuration
DHCP on, for obtaining an IP address
automatically
WAN Provisioning Configuration
Status: on
Device Mode Configuration
Device Mode: Bridge
MTU Rate Setting
MTU Rate: 1460
NTP Configuration
NTP Server: 62.94.7.9
Expires: 86400
Time Zone: +1
LAN Configuration
LAN IP: 192.168.0.1
LAN Mask:255.255.255.0
LAN Gateway: 192.168.0.254
DHCP Configuration
Status: Enable
Mode: Auto
Pool Start IP: 192.168.0.1
Pool End IP: 192.168.0.254
Default Gateway: 192.168.0.1
DNS 1: 192.168.0.1
DNS 2: 0.0.0.0
Domain: eutelia.it
Least time: 86400
VOIP PARAMETERS
VoIP Protocol: SIP (MGCP not_used)
VoIP User (User0)
Username: telephone number
Password: assigned by Eutelia
or modified via WEB
Displayname: telephone number
Login Id: telephone number
VoIP User (User1) if subscribed
Username: 2° telephone number
Password: assigned by Eutelia
or modified via WEB
Displayname: 2° telephone number
Login Id: 2° telephone number
VoIP SIP
Local Port: 5060
Proxy Address : voip.eutelia.it
Proxy Port : 5060
Registration address: voip.eutelia.it
Registration port: 5060
Outbound Proxy Address: 0
Outbound Proxy Port: 5065
Expires: 300
SIP Domain: voip.eutelia.it
Subject: Eut-ATA03a
VoIP Audio Config (Port 1 & 2)
Codec Rate: 30
Preferred Codec : G.729A
VAD: Enable
DTMF Tx Method: RFC-2833 Enable
VoIP RTP
RTP Port: 13456
VoIP Tone
Country Tone: Custom Specific Tone
Rx Gain (db): 0
Tx Gain (db): 0
Ring: 1000, 4000
Dial Tone: 0, 0, 450, 0
Busy Tone: 350, 350, 450, 0
Ring back Tone: 1000, 4000, 450, 0
Call Waiting tone: 4000, 4000, 450, 0
VoIP FAX
T.38 Fax: enable
T.38 Port: 49170
VoIP STUN
NAT Address: ()
1
STUN Server Address: stun.voip.eutelia.it
STUN Server Port: 3478
Local Port: 3478
Expires: 60
Speed Dial (not used)
Call Features (not used)
Port1: all services in off
Port2: all services in off
1
The “NAT Address” item will be updated automatically with the public IP address following the authentication of the ADSL access.