Filter
Top Products
4
Talk and Standby Times
With average use, your handset battery provides approximately 6 hours of talk time and
approximately 12 days of standby time. When your handset is not being used and is left
off of their charging cradle, the battery will gradually discharge. You can achieve optimum
battery life and performance by returning the handset to the charging cradle after each
use. If the handset is left off of the charging cradle, the actual talk time duration will be
reduced respective to the amount of time the handset is off of the charging cradle.
D. Mount the base unit on a wall
Standard wall plate mounting
This phone can be mounted on any standard wall
plate.
1) Plug the AC adapter to the DC IN 9V jack.
2) Plug the AC adapter into a standard 240V AC wall
outlet.
3) Plug the telephone cord into the TEL LINE jack.
4) Route the telephone cord through the groove as
shown.
5) Plug the telephone cord into the telephone outlet.
6) Align the mounting slots on the base with the
mounting posts on the wall. Then push in and
down until the phone is rmly seated.
Direct wall mounting
If you don’t have a standard wall plate, you can mount your phone directly to the wall.
Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind
the mounting location that could cause a hazard when
inserting screws into the wall.
• Try to mount your phone within 1.5m of a working
phone jack to avoid excessive cord lengths.
• Make sure the wall material is capable of supporting the
weight of the base and handset.
• Use #10 screws (minimum length of 35mm) with
anchoring devices suitable for the wall material where
the base unit will be placed.
1) Insert two mounting screws into the wall, (with their
appropriate anchoring device), 100mm apart. Allow
about 3mm between the wall and screw heads for
mounting the phone.
2) Refer to steps 1 through 6 above to mount the
telephone.
35mm
100mm
3mm
35mm
100mm
3mm
XS1410 OM.indd 4 3/6/08 2:01:31 PM