[ 19 ]
System Reset
Deregister the Handset
1) Enter the “System Reset” menu, then the “Deregister HS” submenu
(see “Entering the Menu” on page 14).
2) Press the OK soft key.
3) Press the OK soft key. You will hear a confirmation tone.
When deregistration is complete, “Deregistration
Complete” appears.
4) After deregistering the handset, move to “Deregister the
Base Setting” below.
Deregister the Base Setting
1) Enter the “System Reset” menu, then the
“Replacing Base” submenu (see “Entering the
Menu” on page 14). “Do you want to replace
Base?” appears.
2) Press the OK soft key. You will hear a confirmation
tone.
The base information will be deleted.
When replacing the base is complete, “Please Register” appears, register the
handset(s) to the new base.
3) Place the handset in the base unit to begin registration.
4) While the handset is registering, “Handset Registering” will appear in the LCD.
When “
Registration Complete
” is displayed, the handset has been registered to
the base.
If “Registration Failed“ appears, please try these steps again.
Which Handset?
Handset #1
BACK BACK OK
Are you sure
to deregister
Handset #1?
BACK BACK OK
Do you want to
replace Base?
BACK BACK OK
UP306EH (WDECT2310) ENG OM 1/21/04 8:51 AM Page 19