Filter
Top Products
Registering FIPS Code
Six digit FIPS Codes are programmable in 15 channels, number 1~15
for NWR-SAME Weather Alert. If there is no data registered in location
number 1, all of the signals are decoded. Contact the National Weather
Service at 1-888-NWR-SAME for the FIPS Codes in the area of interest,
or visit http://www.nws.noaa.gov/nwr/indexnw.htm
Press and hold the MEM/FIPS key for 1.5 seconds.
Select the channel, numbers 1~15, you
want to program using the ▲ or ▼ key.
Press the MEM/FIPS key to enter the
FIPS Code edit mode.
To enter the first digit of the code, change
the left blinking digit on the display using
the ▲ or ▼ key and press the MEM/FIPS
key. The right digit starts to blink.
To enter the second digit of the code,
change the right blinking digit on the
display using the ▲ or ▼ key and press
the MEM/FIPS key.
The entered digit moves to the left and
the right digit starts to blink.
Repeat step 5 for the remaining digits of the code.
After the last digit registers, the entered code appears on the
display automatically for confirmation.
To exit from this mode, press and hold the MEM/FIPS key for
1.5 seconds.
Press UIC to clear the stored FIPS Code in the displayed location.
• Pressing the MEM/FIPS key for more than 1.5 seconds in the
middle of the above steps prevents registration.
9
8
7
6
5
4
3
2
1
17
VOYAGER.QX 11/19/2 2:19 PM Page 17