Filter
Top Products
Making and Receiving Calls
4) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL LINE
jack and a telephone outlet.
TIP: If your telephone outlet isn’t
modular, contact your telephone
company for assistance.
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
1) Press and hold the flash key until you hear a confirmation tone in standby mode.
2) To set the dial mode for pulse dialing, press the # key. Or to set the dial mode for tone
dialing, press the /tone key. A confirmation tone sounds to indicate the setting is
complete.
NOTE: • Make sure your battery pack is fully charged before choosing the dial mode.
• If you are not sure of your dialing system, set for tone dialing. Make a trial call. If
the call connects, leave the setting as is. Otherwise set for pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones
for certain situations during a call, you may “switch-over” to tone dialing (Refer to
“Tone Dialing Switch-over”).
4
Handset On Base
Receive call
When the phone rings, remove
the handset from the base
(AutoTalk).
1) Remove the handset from the
base and press the talk key.
Make call 2) The talk/batt low LED
flashes and turns on.
3) Listen for the dial tone.
4) Dial the number.
Hang up Press the end key or return the handset to the base (AutoStandby).
1) Remove the handset from the
base and press the talk key.
Redial 2) Listen for the dial tone.
3) Press the redial/pause key
to dial the last dialed number.
Modular
Using Your Phone
Handset Off Base
Press the talk, /tone, #, or any
number key.
1) Press the talk key.
2) The talk/batt low LED flashes
and turns on.
3) Listen for the dial tone.
4) Dial the number.
1) Press the talk key.
2) Listen for the dial tone.
3)
Press the
redial/pause
key to dial
the last dialed num
ber.