GETTING STARTED
GETTING STARTED [ 17]www.uniden.com
1) When the phone is in the standby mode, press and hold
cid/menu. The following screen appears.
2) Press vol/ring/ key three times to select ¨
Dial¨.
3) Press select to toggle between ¨
Tone¨ and ¨Pulse¨ for
each setting.
4) Press end or return the handset to the base unit to complete the setting.
The handset returns to the standby mode.
• If you are not sure of your dialing system, set for tone dialing. Make a trial call.
If the call connects, leave the setting as is, otherwise set for pulse dialing.
• If your phone system requires pulse dialing and you need to send the DTMF tones for
certain situations during a call, you may "switch-over" to tone dialing. (Refer to
"Tone Dialing Switch-over" on page 20.)
Setting the language
1) When the phone is in the standby mode, Press and hold
cid/menu. The following screen appears.
2) Press vol/ring/ key four times to select ¨
Language¨.
3) Press select to toggle between ¨
Eng¨ and ¨Fr.¨ for each
setting.
4) Press end or return the handset to the base unit to complete the setting. The
handset returns to the standby mode.
EXI3246 3/6/3 10:00 AM Page 17