Filter
Top Products
Register the Handset
YOU NEED TO REGISTER THE DCX520 BEFORE USE.
1
After placing the batteries in the handset and charging the
batteries, remove the handset from the charger and place it
in the main base.
2
Registration starts automatically. While registering,
“Handset Registering” appears in the display.
3
When the registration is complete,
“Registration Complete” appears in the display.
If the registration fails, “Registration Failed” appears in
the display. Try the steps above again.
•An extra handset can be registered when the main base
is in the standby mode.
•In some cases you may need to attempt registration a
few times.
– 5 –
Using the DCX520 with the
Integrated Answering Device
If the original unit has a built-in answering system, you can check
your new messages, skip, repeat, or delete your messages with the
DCX520 handset. For more instructions, see the owner’s manual
supplied with the original unit.
•Use only the supplied AD-310
AC adapter. Do not use any
other AC adapter.
•Place the charger close to the AC
outlet so that you can unplug the
AC adapter easily.
3
Make sure the charge LED illuminates. If the LED does not
illuminate, check to see that the AC adapter is plugged in
and that the handset makes good contact with the charger
charging contacts.
Polarity of the plug
DCX520_UU820BH UU01820BZ_1 1/16/03 9:59 AM Page 5