Filter
Top Products
Recharging the Nickel-Cadmium Battery Pack
Note: Before charging, be sure that the power (ON/OFF
Volume control) is turned OFF.
Recharge the Ni-Cd Battery ONL Y when the unit
indicates a LOW BA TTERY condition.
(TX LED blinks during TRANSMIT)
Insert the discharged Battery Pack in the rapid charger, or
connect the trickle charger to the side of the unit.
Using the trickle charger, the standard pack charges fully in
8 hours, and the heavy duty pack in 12 hours. If you have a
rapid charger, the standard pack charges fully in 1.5 hours,
and the heavy duty pack charges fully in 2 hours.
DO NOT leave the Batteries on charger for an extended
period of time.
Belt Clip Installation
Place the Belt Clip on the
mounting area on the back of
the radio, making sure the
holes in the clip line up with
the threads in the back of the
radio.
@
@
Insert the 2 screws into the
corresponding holes and
tighten.
BeltClip
I88II!n I'tOOEL,SPD1
lOB.00UtIIIJWWaf BAI1ERI
IX:7Zt- coo:
-...-
DODO
CAUTION:
DO NOTtighten the screws too tight, you could damage the
case.
UH-O56
Page 10