Filter
Top Products
7
Replace the Rechargeable Handset Battery Pack
Remove the four screws
holding the battery
compartment with a
screwdriver and take off
the battery cover. Remove
the old battery pack from
the battery compartment.
Line up the red and black
wires with the polarity label
in the battery compartment
(the connector only ts one
way). Push the connector
in rmly; you should hear
the connector click into
place.
Tug on the battery wires
slightly to make sure you
have a good connection.
Before placing the battery
cover back on the handset,
check the rubber seal
located on the under side
of the cover: make sure
that the seal is in good
condition and that there
is no foreign matter under
the seal.
Note: If the rubber seal
appears warn, nicked, or dried
out, replacement seals are
available through the Uniden
Parts Department. See the
back cover page for contact
information.
1)
2)
3)
4)