Uniden Solara DSC Two-Way Radio User Manual


 
26
If the SOLARA DSC does not perform to your expectations, try the
suggestions listed below. If you cannot get satisfactory results, call the
Uniden Technical Support at (800) 586-0409, 8:00 a.m. to 5:00 p.m.,
Central Standard Time, Monday through Friday.
Troubleshooting
CAUSE
No or low voltage.
Bad mic element.
A source of noise is
nearby.
An external noise is
being generated by
some device.
SYMPTOM
Wont power On.
When the PTT is
pressed - Tx comes
on and another
radio can hear a
click but no audio
is heard.
While scanning, the
radio stops on a
particular channel all
of the time.
There is noise on
the receiver that the
squelch will not
eliminate.
REMEDY
Check for proper voltage
getting to the set.
Send in for repair.
Eliminate the source of
the noise or briefly press
the channel or
channel key.
Either turn off the
offending device or
contact that Mfg.
Regarding FCC part 15
unintentional radiator.
SOLARA_UT600AH_ENG_0817 8/17/04 11:16 AM Page 26