Filter
Top Products
[ 10 ] GETTING STARTED
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However some phone systems still use pulse dialing such as in rural areas.
The default setting is tone dialing. Depending on your dialing system, set the mode
as follows:
•If you are not sure of your dialing system, set for tone dialing. Make a trial call. If
the call connects, leave the setting as is, otherwise set for pulse dialing.
•If your phone system requires pulse dialing and you need to send the DTMF tones
for certain situations during a call, you may "switch-over" to tone dialing. (Refer
to "Tone Dialing Switch-over" on page 15.)
5)Connect the telephone line cord to the TEL LINE jack and
to a telephone outlet once the handset is fully charged.
If your telephone outlet
isn't modular, contact your
telephone company for
assistance.
Modular
• After installing the battery pack in the handset, charge your handset at least
15-20 hours before plugging into the phone line. Once the handset battery
pack is fully charged, connect the telephone line cord to the base and
telephone wall outlet.
If your dialing system is
Tone
Pulse
Set the switch to
TONE
PULSE
PULSE -TONE DC IN 9V TEL LINE
EXT1160/1165 ENG-0726 7/26/01 15:53 Page 10