YOU NEED TO REGISTER THE DSS2405 TO THE MAIN BASE
BEFORE USE!
1
After placing the batteries in the handset, charge for 10
minutes. Then remove the handset from the charger and
place it in the main base (DSS2415, DSS2455, or DSS2465).
2
Registration starts automatically. While registering, “Handset
Registering” appears in the display.
3
When the registration is complete, “Registration
Complete” appears in the display.
If the registration fails, “Registration Failed” appears in the
display. Try the above steps again.
4
Once registration is complete, place the handset back in
the charger for 17 to 20 hours to ensure the batteries are
fully charged.
•An extra handset can be registered when the main base
is in the standby mode.
•In some cases you may need to attempt registration a
few times.
Register the Handset
Cleaning the battery charging contacts
To maintain a good charge, it is
important to clean the charging contacts
on both the handset and the charger
once a month. Use a dry cloth or pencil
eraser to clean.
contacts
– 5 –
DSS2415
Main Base
DSS2455/2465
Main Base
Charger
UU827BH ENG (DSS2405) 8/6/03 11:07 AM Page 5