Filter
Top Products
47
Answering an Intercom Page
When the intercom page tone sounds, the display will show the ID of the station that is
paging.
Press [ /ash], [int’com/hold], or the ANSWER soft key on the handset (or
[int’com/hold], [ ], or the ANSWER softkey on the base). Or press a number key,
[
tone
/<], or [#/>] (when Any Key Answer is enabled), or pick up the handset from the
cradle (when AutoTalk is on).
To hang up an intercom page, press the END soft key or [ ] on either handset (or
[int’com/hold] on the base).
Note:
If the party is busy, the handset returns to standby.
If the party is out of range, UNAVAILABLE appears in the display and the operation will be canceled.
If you receive an outside or intercom call or page while selecting the other handset, the operation is canceled.
If you do not select a handset within 30 seconds, the operation will be canceled.
If the party does not answer within one minute, the operation is canceled.
Room Monitor
This feature allows you to monitor sounds in another room. Place a station in the room you wish to monitor; it will
function as a microphone. Another station can be set to function as a remote speaker, allowing you to monitor
sounds in the room.
Press the MENU soft key and enter ROOM MONITOR menu. TO ROOM MONITOR appears.
Select the handset or base you want to monitor by using [ ] or [ ].
Press the OK soft key. ROOM MONITOR appears on the handset, and you hear
sounds in the room where the handset or base is installed.
To turn off the Room Monitor, press the END soft key or [ ] on either handset or return
the handset to the cradle.
1)
2)
•
•
•
•
•
1)
2)
3)
4)
+PVGTEQO
㨬㨬
*CPFUGV
#059'4
+PVGTEQO
㨬㨬
*CPFUGV
#059'4
4QQO/QPKVQT
㨬㨭
*CPFUGV
'0&
4QQO/QPKVQT
㨬㨭
*CPFUGV
'0&