Filter
Top Products
– 4 –
Step 2: Register the Handset
YOU NEED TO REGISTER THE DCX770 TO A MAIN BASE BEFORE USE!
1
Be sure the handset battery is fully charged.
2
With the main base in standby mode (i.e., not being used), place
the handset in the main base to begin registration.
For compatible models in the DCT6 and DCT7 series:
1)Disconnect the AC adapter.
2)While holding the following key, connect the AC Adapter:
DCT646 & DCT746 models - find handset
DCT6465 & DCT6485 models - intercom
DCT648 models - intercom/find handset
DCT748 models - find/skip
Keep pressing the key until the CHARGE LED starts to blink.
3)On the handset, press and hold # until you hear beep.
For compatible models in the DCT7488 series:
1)Press the MENU soft key in the standby mode.
2)Select
HS Registration
, and press the OK soft key.
3)On the handset, press and hold # until you hear beep.
3
While the handset is registering,
Handset Registering
will
appear in the handset LCD. When
Registration Complete
is
displayed, the handset has been registered to the base.
If
Registration Failed
appears, please try these steps again.
De-register the handset
1)Press and hold end and # for more than 5 seconds.
2)Select the handset ID to be de-registered from the list.
The phone will ask you to confirm the deregistration. Select
Yes
.
To de-register expansion handsets DCX640 or DCX700, refer
to their owner's manual or download from Uniden's website
at www.uniden.com.