Filter
Top Products
22 - English
FCC PART 15.105(b): Note: is
equipment has been tested and found
to comply with the limits for a Class
B digital device, pursuant to part 15
of the FCC Rules. ese limits are
designed to provide reasonable protec-
tion against harmful interference in a
residential installation. is equip-
ment generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
o and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
x Reorient or relocate the receiving
antenna.
x Increase the separation between the
equipment and receiver.
x Connect the equipment into an outlet
on a circuit dierent from that to which
the receiver is connected.
x Consult the dealer or an experienced
radio/TV technician for help.
FCC RF Exposure Information
is product complies with FCC radia-
tion exposure limits under the follow-
ing conditions:
x e base must be placed to allow a
minimum of 20 cm (8 inches) between
the antenna and all persons during
normal operation.
x e base must not be collocated or
operated in conjunction with any other
antenna or transmitter.
x e handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory sup-
plied with this product. (All necessary
accessories are included in the package;
any additional or optional accessories
are not required for compliance with
the guidelines.) ird party accessories
(unless approved by the manufacturer)
should be avoided as these might
not comply with FCC RF exposure
guidelines.
Disable All Functions Except
Charging
D1880 Base
1. Press and hold
skiP
and
Vol +
simultaneously, then plug in the AC
adapter.
2. Continue to hold the keys for about 5
seconds. When the message counter
turns off, all functions are disabled
except for charging.
D1880 Handset
1. Install the battery.
2. When the “Welcome, please wait...”
message disappears from the display,
press and hold
End
,
MEnu
, and
*
simultaneously.
3. After about 5 seconds, a
confirmation tone sounds,
indication all functions except
charging are disabled.
To return to normal operation,
cycle the power for the base and
remove and reinstall the handset
battery.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: is equipment meets the
applicable Industry Canada Terminal
Equipment Technical Specications.
is is conrmed by the registration
number. e abbreviation IC before
the registration number signies that
registration was performed based on a
Declaration of Conformity indicat-
ing that Industry Canada technical
specications were met. It does not
imply that Industry Canada approved
the equipment.