Filter
Top Products
English - 19
Answering system problems Possible solutions
The system keeps recording
when I answer on an
extension.
x You may have to change the line
mode. Contact Customer Service for
instructions.
Installing a Line Filter or DSL Filter
A telephone line lter or DSL lter prevents services that use the phone line from
causing interference on your phone. To get a line lter, contact your service pro-
vider or look in an electronics store.
Plug the lter into the telephone wall jack and plug the base into the lter. Make a
test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter & phone
cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it o and
use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces
down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers & reconnecting cords.
Resetting Handsets
If you have trouble with a handset or if you want to replace one, clear the registra-
tion information from the base and the handset:
1. Press & hold
End
and
#
at the same time until you see the
System Reset
menu.
2. If you still have the base the handset is registered to, select
Deregister HS
, then
select the handset you want to reset. If you don’t have that base anymore, select
Base Unavailable
.
3. To conrm, select
Yes
. e handset displays
Handset not registered
.
Registering Handsets
If you see a “not registered” message on a handset, you must register it to a base
before using it.
1. Place the handset in the base; the display should say
Handset Registering
.
2. Wait until the display says
Registration Complete
(about 30 seconds), then pick
up the handset and press
Talk/flash
.
3. If you don’t hear a dial tone or the display says
Registration Failed
, charge the
battery completely, then try again.