Filter
Top Products
English - 14
Voice mail issues Possible solutions
The new message icon doesn’t turn off
after I’ve listened to all my messages.
x Reset the Voice Message
Indicator (see p. 13).
Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the phone line
from causing interference on your phone. To get a line filter, contact your
service provider or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the filter.
Make a test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter &
phone cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off
and use as normal. If you can hear liquid inside the housing:
1. Remove all compartment covers, and disconnect all cables and cords.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces
down. If not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before
replacing compartment covers & reconnecting cords.
Resetting Handsets
If you have trouble with a handset or if you want to replace one, clear the
registration information from the base and the handset:
1. Press & hold
End
and
#
at the same time until you see the
System Reset
menu.
2. If you still have the base the handset is registered to, select
Deregister
HS
, then select the handset you want to reset. If you don’t have that base
anymore, select
Base Unavailable
.
3. To confirm, select
Yes
. The handset displays
Handset not registered
.
Registering Handsets
If you see a “not registered” message on a handset, you must register it to a
base before using it.
1. Place the handset in the base; the display should say
Handset Registering
.
2. Wait until the display says
Registration Complete
(about 30 seconds), then
pick up the handset and press
Talk/Flash
.