Filter
Top Products
English - 9
Chain Dialing
If you often have to enter a series of digits or a code number during a call,
you can save that code number as a regular phonebook entry and use the
phonebook to send the code number.
Make a call normally. When you hear the prompt that asks you to enter your
number, open the phonebook and find the entry. Press
MENu/sELEcT
to send
the code. If you change your mind, just close the phonebook.
Using Call Waing
x Call Waiting, a service available from your telephone provider, lets you
receive calls while you are on another call. Caller ID on Call Waiting
(CIDCW) service displays Caller ID information for a waiting call.
x If you get a Call Waiting call, the phone sounds a tone. Press
TaLk/fLash
to
switch between the current call and the waiting call; each time you switch,
there is a short pause before you’re connected to the other caller.
Mul-Handset Features
# To use the features in this section, you need at least 2 handsets.
Handset to Handset Intercom
x You can make an intercom call from any handset, but only two handsets
can be in an intercom call at any time.
x If an outside call comes in during an intercom page, the phone cancels the
page so you can answer the incoming call.
x If an outside call comes in during an intercom call, press
TaLk/fLash
to hang
up the intercom call and answer the outside call.
To page another handset To answer the page
1. With the phone in standby, press
INTErcoM/cLEar
.
2. Select the handset you want to page, or select All.
(To cancel, press
ENd
.)
Press
TaLk/fLash
or
INTErcoM/cLEar
.
To end an intercom call, press
ENd
. Both handsets return to standby.
Call Transfer
To page another handset To answer the page
1. During a call, press
INTErcoM/cLEar
. The phone
puts the call on hold.
2. Select the handset you want to page, or select All.
(To cancel and return to the call, press
TaLk/fLash
.)
3. When the other handset accepts the call, you’ll be
disconnected (press
TaLk/fLash
to rejoin the call).
1. Press
INTErcoM/
cLEar .
Speak to
the other handset.
2. Press
TaLk/fLash
to speak to the
caller.