Filter
Top Products
USING YOUR PHONE
Basics
To... Follow these steps…
make a call Press
Talk
and then dial the number.
answer a call Press
Talk
.
hang up Press
End
or put the handset in the cradle.
redial a number Press
Talk
and then press
rEdial
.
mute the microphone
during a call
Press
MUTE
. Press again to turn the microphone
back on.
mute the ringer for this
call only
While the phone is ringing, press
MUTE
or
End
.
(The handset must be off the cradle before the
phone starts ringing.)
Adjusng the Ringer Tone and the Earpiece Volume
Change the When Follow these steps…
ringer tone
the phone is
in standby
Press
UP
or
down
to cycle through the 2
ringer tones at low, medium, and high
volume; when you hear the tone and
volume combination you want to use, stop.
earpiece volume during a call
Press
UP
or
down
to select one of the 6
volume levels.
Using Call Waing
If you subscribe to Call Waiting service through your telephone company and a
call waiting tone sounds while you are on a call, press
Flash
to switch between
the current call and the waiting call; each time you switch, there is a short pause
before you’re connected to the other call.
Using Memory Dial
You can enter ten different phone numbers (up to 20 digits each) in the phone’s
dialing memory. Each memory dial entry is assigned to one of the number keys
(
0
-
9
) on the twelve-key dial pad.
Storing numbers in memory dial
1. With the phone in standby, press
MEMory
. The
Talk/baTT low
light flashes.
2. Use the keypad to enter the phone number exactly as you would dial it.
x If you need the phone to wait before sending the next set of numbers, press
PaUsE
to insert a two-second pause. Each pause counts as a digit.
x If you don’t press any keys for 30 seconds, the phone times out and returns
to standby.
3. Press
MEMory
again.
4. Press the number key (
0
-
9
) you want to assign to this memory dial entry.
You will hear a confirmation tone.
#When you assign a memory dial entry to a number key, the phone
automatically overwrites any previous entry assigned to that key.
Dialing a memory dial entry
1. When the phone is in standby, press
Talk
.
2. Press
MEMory
.
3. Press the number key assigned to the memory dial entry you want to use.
#If you press a number key with no assigned memory dial entry, the
handset beeps, and the phone will not dial.
Erasing a memory dial entry
1. With the phone in standby, press
MEMory
twice.
2. Press the number key assigned to the entry you want to erase. You will hear a
confirmation tone.
Chain dialing
If you often have to enter a code number during a call, you can use memory dial
to transmit the code number.
1. Store the code number (up to 20 digits) into memory dial just like a regular
entry.
2. Make your call normally. During a call, when you hear the prompt that tells
you to enter the number, press
MEMory
followed by the number key assigned
to the entry you want to use.
Finding the Handset
With the phone in standby, press
Find
on the base. The handset will beep for 1
minute or until you press
Find
again. You can also end the page by pressing any
key on the handset.
IMPORTANT INFORMATION
Solving Problems
If you have any trouble with your phone, try these simple steps first. If you need
help, call our Customer Care Line listed on the front cover.