Filter
Top Products
4
Talk and Standby Times
With average use, your handset battery provides approximately 6 hours of talk time and
approximately 7 days of standby time. When your handset is not being used and is left
off of their charging cradle, the battery will gradually discharge. You can achieve optimum
battery life and performance by returning the handset to the charging cradle after each
use. If the handset is left off of the charging cradle, the actual talk time duration will be
reduced respective to the amount of time the handset is off of the charging cradle.
D. Mount the base unit on a wall
Standard wall plate mounting
This phone can be mounted on any standard wall
plate.
1) Plug the AC adapter to the DC IN 9V jack.
2) Plug the AC adapter into a standard 120V AC wall
outlet.
3) Plug the telephone line cord into the TEL LINE
jack.
4) Route the telephone line cord through the groove
as shown.
5) Plug the telephone line cord into the telephone
outlet.
6) Align the mounting slots on the base with the
mounting posts on the wall. Then push in and
down until the phone is rmly seated.
Direct wall mounting
If you don’t have a standard wall plate, you can mount your phone directly to the wall.
Before doing this, consider the following:
• Avoid electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the
wall.
• Try to mount your phone within 5 feet of a working phone jack to
avoid excessive cord lengths.
• Make sure the wall material is capable of supporting the weight of
the base and handset.
• Use #10 screws (minimum length of 1-3/8 inches) with anchoring
devices suitable for the wall material where the base unit will be
placed.
1) Insert two mounting screws into the wall, (with their appropriate
anchoring device), 3-15/16 inches apart. Allow about 1/8 of an
inch between the wall and screw heads for mounting the phone.
2) Refer to steps 1 through 5 above to mount the telephone.
E. Choose the dialing mode
Most phone systems use tone dialing. However, some phone systems (such as in rural
areas) still use pulse dialing. Your Uniden phone supports both tone and pulse dialing.
The default setting is tone dialing. If your phone system uses pulse dialing, follow the
steps below to change the dialing mode:
1) In standby, press and hold [ash] until you hear a conrmation tone.
2) Press [#] to set your phone for pulse dialing. You will hear a conrmation tone.
If you need to reset your phone to tone dialing, press and hold [ash] until you hear the
conrmation tone. Then press [ /tone] to restore the tone setting.
NOTE:
• Make sure your battery pack is fully charged before choosing the dial
mode.
• If you are not sure of your dialing system, make a trial call. If the call
connects, leave the setting at tone dialing. Otherwise, set for pulse dialing.