Filter
Top Products
36
TROUBLESHOOTING
Additional Information
PROBLEM SOLUTION
•
The handset is located away from the base or the battery has been
discharged.
→ Return the handset to charge when finished your call.
•
The digital security code is changed.
→
Remove the handset from the base unit and press and hold
.While the handset is emitting, return the handset to the
base unit.
• The ringer volume is set to OFF.
→ Turn the ringer volume ON.
• The battery is low.
→ Place the handset on the base unit to recharge.
• The charging contacts of the handset and the base are not
clean.
→ Clean them with a dry cloth.
• The AC adaptor of the base unit is disconnected.
→ Plug the AC adaptor firmly into the base unit and AC 120V outlet.
• The handset is not on the base.
→ Place the handset on the base properly.
• The handset is too far from the base unit.
→ Bring the handset near the base unit.
• The battery is low.
→ Place the handset on the base unit to recharge.
• The base unit is located in a place with high interference.
→ Relocate to another outlet.
• Interference from TV, Microwave oven, computer and electrical
appliances.
→ Press to select a clearer channel, or relocate the base
unit.
• Excessive line noise.
→ Check with another telephone.
• The volume control is set too high.
→ Reduce volume to a lower setting.
• The base antenna is not in a vertical position.
→ Lift the antenna to a vertical position.
• The phone needs to be reset.
→ Disconnect the AC adaptor and reconnect it within 2 minutes to
avoid memory loss.
CHANNEL
PAGE
The handset does not ring
or receive a page.
CHARGE LED will not light
when the handset is
placed on the base.
Noise or interference
The unit does not operate
properly.
SX-2801.qxd 3/15/1 6:03 PM Page 36