Filter
Top Products
6 Topcom Butler 3400/Twin/Triple/Quattro
Topcom Butler 3400/Twin/Triple/Quattro
* Only when the network sends the time/date together with the telephone number!!! On
some networks with caller ID, time and date will not be displayed
6.3 Calling a number from the Call list
Scroll through the Call list until the desired number is shown on the display. Î Press the
Line button . The number will be dialled automatically.
6.4 Erasing a number from the Call list
Scroll through the Call list until the desired number is shown on the display. Î Press and
hold the Mute button for 3 sec. to erase the number.
6.5 Store a number from the call log into the memory
Scroll through the Call list until the desired number is shown on the display. Î Press and
hold the Memory button for 3 sec.
Î Enter the memory location (0-9) where you want to
store the number.
Î Enter the Memory button again to confirm and to go back to standby.
7 Register/de-register a handset
7.1 Register to a Topcom B3400 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
You only need to subscribe the handset if:
•The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• You want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 34xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Line/Charge indicator
on the base unit begins to blin
k rapidly. The Line/Charge indicator will blink rapidly for one
minute. During this minute, the base unit is in register mode and you must do the following
to subscribe the handset:
Press and hold the key for 3 sec, then press and hold the * key for 3 sec.
Enter the number of the base unit you would like to subscribe the handset to (1-4).
Î The
unit will start searching for the base and when found it will ask to enter the pin code (4 digits).
Enter the base pin code (0000). If the pin is wrong, the handset will restart the searching for
the base.
Î When the handset is registered, it will show ‘HS’ followed by the handset
number.
7.2 Removing a handset
You can remove a handset from a base to allow another handset to be registered:
Press and hold the key for 3 sec, then press and hold the key for 3 sec.
Enter the pin code (0000). If the pin is wrong, the handset will go back to standby.
Enter the handset number (1-4) you want to remove
Î The unit will go back to standby is
the removal is successfully. If not, it will ask again to enter the handset number.
You can only remove existing handsets and others then the one you are
using.