Filter
Top Products
if your additional handset is a 2500/2505/2510/2550/2560/2561/2562/2600/2605/2610/
2660/2661/2662/2700/2705/2710/2750/2760/2761/2762
3. Enter the menu by pressing /OK
4. Select REGISTRATION using the and keys
5. Press OK
6. Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
7. Enter the BASE PIN code (0000 by default )
8. Press OK. The handset will start searching for the DECT base
9. If the handset has located the base, it will display the base identification number, validate the
base registration by pressing OK or stop by pressing ,
10. If the handset does not locate the base, it will return to the standby mode after a few seconds.
Try again by changing the base number and check that you are not in a environment where there
is interference. Move closer to the base.
if your handset is another model
After starting the registration procedure on the base, register the handset (see handset manual to find
out how). The handset must be GAP compatible.
The icon and the text "NOT REGISTERED" flashes on the display when the handset is not associated
with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this num-
ber that is displayed on the handset after the name and must be used for internal calls.
7.2 REMOVING A HANDSET
You can remove a handset with a base to allow another handset to be registered
1. Enter the menu by pressing /OK
2. Select setup using the and keys
3. Press OK
4. Select REMOVE HS using the and keys
5. Press OK
6. Enter the 4 digit base PIN code
7. Press OK
8. Select the handset to be removed
9. Press OK to validate
30 Topcom Butler 2562
ENGLISH
HL_B2562_v3.qxd 24-03-2003 10:01 Page 30