Filter
Top Products
Topcom Butler 1600/Twin/Triple/Quattro 15
Topcom Butler 1600/Twin/Triple/Quattro
ENGLISH
8 Register/de-register a handset
8.1 Register to a Topcom B1600 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
• The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• If you want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler 16xx handset and base unit!!
Keep the Paging key on the base unit pressed for 10 seconds until the Charge indicator on
the base unit begins to blink rapidly. The Charge indicator will blink rapidly for one minute.
During this minute, the base unit is in register mode and you must do the following to
subscribe the handset:
Press Menu button ÆUse the Right button to scroll to ‘REGISTER’ and press OK
Æ Enter the number of the base unit you would like to subscribe the handset to (1-4) Æ The
unit will start searching for the base and when found it will ask to enter the pin code (4 digits):
Æ Enter the base pin code (0000) and press OK . Æ If the pin is wrong, the handset will
restart the searching for the base. Æ When the handset is registered, it will show ‘HS’
followed by the handset number.
8.2 Removing a handset
You can remove a handset from a base to allow another handset to be registered:
Press Menu button ÆUse the Right button to scroll to ‘REMOVE HS’ and press OK
Æ Enter the pin code (0000) and press OK Æ Enter the handset number (1-4) you want
to remove and press OK . Æ The unit will go back to standby is the removal is successfully.
If not, it will ask again to enter the handset number
9 Call transfer and Intercom between two handsets
9.1 Call transfer and conference call during an external call
During an external call, press the INT key followed by the number (1-4) of the other handset.
Æ The other handset will start to ring:
– When the other handset takes the line you can talk internally.
If you hang up, the external line will be connected with the other handset.
You can only remove existing handsets and others then the one you are
using.
These functions only work when more then one handset (like a Twin/Triple/
Quattro version) is registered to the base!