Filter
Top Products
42 43
Remark
• When you are at the top of the list (last call), “head of list” is shown. Press “2” to go
back.
• When you are at the beginning of the list (oldest call), “tail of list” is shown. Press “1”
to go down.
• If the number has more than 9 digits, press “3” to see the rest of the number.
7.2.3 To erase a stored number
When you want to erase a number from the Caller-ID List, press and hold the
number “8” for about 1 second. The number will be erased from the Caller-ID
List.
7.2.4 To erase the entire list
It is possible to erase all the calls from the Caller-ID List that have already been
read (no new, nor unread calls). Erasing the calls is only possible when the total
number and new calls is shown on the display.
• Press the Set button in standby mode to go to the Set menu.
• Press the Paging button and the total number and the new calls are shown on
the display.
• Press and hold “8” for 1 second and the phone asks your confirmation to
erase the calls.
• Press “8” again to confirm or press another button to stop the phone from
erasing the calls.
• After having erased the calls, only the number of new calls is shown on the
display.
8 TROUBLESHOOTING
The handset does not ring
• Are the batteries charged ? (check if the display is working)
• Perhaps the handset is programmed not to ring (see 6.5.1 Ring volume of
handset)
The display does not function
• Check if the batteries are connected well.
• Check if the battery charger contacts are not damaged or dirty.
Indicators on the base station do not function
• Check if the adaptor and the telephone plug have been connected in the
c o r rect socket on the bottom of the base station.
• Check the power supply of the adaptor.
• Check if the delivered adaptor has been used.
Bad connection
• The handset is too far away from the base station, move closer.
You hear an intermittent beep during the conversation
• You are too far away from the base station, if you do not move closer to the
base station within 10 seconds, the conversation will be broken.
• Possibly the 15 minutes conversation timer is activated. Press a numerical
button (0-9) to continue the conversation.
• When the battery symbol appears on the display of the handset or the low
battery indicator lights, the battery needs to be charged.
9 SETTINGS
Clear all memory. Clears the following memories :
1 x
• Erases redial memory
• All phone number memories
• Flash time is set as flash 100ms
• Erases all PABX codes
R function programming
2 x
x= 1 : /
x= 2 : flash 100 ms
x= 3 : flash 115 ms
x= 4 : flash 270 ms
x= 5 : flash 600 ms
PABX access code
3 x y z
x= 1 : PABX group 1
x= 2 : PABX group 2
x= 3 : PABX group 3
y= 1 : 3 seconds pause (1P)
y= 2 : 7 seconds pause (2P)
z= PABX access code (max 2 digits)
Key tone
4 x
X=1 : Key tone ON
X=2 : Key tone OFF
Butler 131/136 Butler 131/136