Topcom 132 Cordless Telephone User Manual


 
23
3 Battery Empty indication
When the battery is empty, the handset no longer carries out operations.
The Battery symbol appears for 10 seconds on the display and then the
handset will be deactivated until the battery is re c h a rged. When a battery is
completely empty and you have put the handset on the base unit for a
s h o rt period of time, the Battery symbol will appear to be fully charged but
this is actually not the case. The battery capacity will decrease rapidly. We
advise you to put the handset on the base unit for the entire night so that it
can be re c h a rged thoro u g h l y.
Full battery [ ]
Empty battery [ ]
When you are in the middle of a conversation and the battery is almost
empty, the handset will emit a warning signal every 2 seconds. After
3 minutes the handset will be deactivated. Place the handset on the base
unit to charge.
4 Operation telephone
4.1 Outgoing calls
4.1.1 Making a phone call
Press the Line button. You will hear the dial tone.
Enter the desired telephone number.
Press the Line button when you want to terminate the call.
4.1.2 Call setup with dial preparation
Enter the desired telephone number. An incorrect number can be
corrected by means of the Mute button. When you haven’t pressed a
button for 15 seconds, the number you’ve already entered will
disappear and the handset returns to standby mode.
Press the Line button. The number will be dialled automatically.
Press the Line button when you want to terminate the call.
Note : When you want to dial a new number and you are already on the phone,
p ress and hold the Line button for one second. You will hear two beeping sounds.
As soon as you hear the dial tone, enter the new telephone number. The entere d
number is shown on the display.
4.2 Incoming calls
When a call comes in, the base unit as well as the handset will start
to ring. The PHONE symbol blinks on the display.
Press the Line button to answer the incoming call.
Butler 132/137