Topcom 1300 Two-Way Radio User Manual


 
TOPCOM TWINTALKER 1300 7
TOPCOM TWINTALKER 1300
ENGLISH
12.2 ADJUSTING SPEAKER VOLUME
The Speaker Volume can be adjusted using / . The Speaker Volume level is displayed on the LCD.
12.3 RECEIVING A SIGNAL
The unit is continuously in the RECEIVE mode when the unit is ON and not transmitting. When you
receive a signal on the current channel, the RX icon is displayed.
12.4 TRANSMITTING A SIGNAL
• Press and hold to TRANSMIT.
• Hold the unit in a vertical position with the MICROPHONE 10 cm from the mouth and speak into the
microphone.
• Release when you have finished transmitting.
12.5 CHANGING CHANNELS
The PMR has 8 available channels.
To change channels:
• Press once, the current channel number flashes on the LCD Screen.
• Press or to change the channel.
• Press to confirm the channel selection and return to NORMAL mode.
NOTE: Any PMR set on the same channel can receive and listen to the conversation.
12.6 MONITOR
You can use the MONITOR feature to check for weaker signals in the current channel.
Press button for normal monitoring .
Press and hold . After 5 seconds you can release the button. You are now continuous monitoring the channel
until you press again.
12.7 CHANNEL SCAN
CHANNEL SCAN performs searches for active signals in an endless loop from channel 1 to 8.
• Press and hold and for 2 seconds.
• Release the buttons.The channel on the display changes as it scans through the channels.
• When an active signal (one of 8 channels) is detected, CHANNEL SCAN pauses and you will hear the
active signal.
• When an active signal (one of 8 channels) is detected, press or to bypass the current channel
and continue to search for another active channel
• Press to communicate through the active signal channel or press to deactivate channel
scan.
SC
TX RX
SC
TXRX
In order for other people to receive your transmission, they must be set
on the same channel.
SC
TXRX
PTT
PTT
SC
TX RX
PTT
SC
TX RX
PTT
HL_TT_1300_all.book Page 7 Wednesday, August 25, 2004 10:53 AM