Filter
Top Products
INCLUDED IN YOUR PACKAGE
Cordless Handset
NiMH Battery
Rubber Battery Screw Cover
Phillips Screw
Base Unit
AC Adapter
10 foot, 4 Wire RJ- 11 Line Cord
15 foot, 8 Wire RJ- 45 Cable
Clear Plastic Overlay
User Guide
PREPARING TO USE THE CL2900 SERIES TELEPHONE
1. Prepart to install the battery into the cordless handset by firmly pressing down on the
top of the battery cover and sliding it off.
2. Locate the lightly embossed numbers “1” and “2” on the battery’s plastic connector.
3. Insert the battery connector into the Handset’s connector with the embossed numbers
facing up.
Note: The handset may “beep” when the battery is connected. This is not an indica-
tion that the telephone is ready to use. To obtain optimal performance of the tele-
phone, be sure to charge the battery for 15 to 20 hours.
4. Replace the battery compartment cover and retaining screw.
5. Insert the provided rubber screw cover.
6. Turn the telephone Base so the back panel is facing you. Insert either end of the RJ-45
cable into the jack on the back of the telephone labeled LINE.
7. Insert the other end of the cable into the jack on the AC adapter labeled PHONE.
8. Insert one end of the RJ-11 line cord into the jack on the AC adapter labeled LINE.
9. Insert the other end of this line cord into a telephone wall outlet jack.
10. Plug the AC adapter into an available, unswitched electrical wall outlet.
11. Once your telephone is connected, remove the plastic overlay by hooking the tabs on
the overlay into the recessed slots located on both sides. The overlay is easiest to insert
when; the left or right side tabs are inserted first, and the middle of the overlay is
slightly bowed to allow for insertion of the other tabs.
12. Place the Cordless Handset on the Base Unit.
CHARGING THE BATTERY
The rechargeable Nickel Metal Hydride battery must be fully charged before using the
phone for the first time. It is recommended that that battery pack be charged for approxi-
mately 15 - 20 hours, without interruption, before use.
To charge the battery, place the Handset, keypad down, in the base unit. Make sure the
“Charge” LED on the base lights. If the LED does not light:
1. Check to see if the AC adapter is plugged in
2. The AC adapter is NOT plugged into a switched outlet,
3. The Handset bottom is making good contact with the Base Unit charging contacts.
CL2900 SERIES TELEPHONE DIAGRAM
CONTACTING TELEDEX
Telephone: (408) 363-3100
Mail: 6311 San Ignacio Avenue
San Jose, CA USA 95119
Internet: www.teledex.com
email: sales@teledex.com
Part Number 600-0480-45
Copyright © 2001 Teledex LLC. All rights reserved.
1
Charge LED
Store Key
Flash Key
Programming Port
Auto Dial Keys
M1-M5
(model CL1905)
M1-M10 (model CL1910)
DTMF Keys
Handset
Volume Keys
Mute
Message Waiting Lamp
Hold Button
Line1 Line2
Conference
Speakerphone
Hold
Line 1
Line 2
Redial/Flash
Handset
Volume
Keys
Channel
Conference
Modular Phone
Line Jack
Data Port
Page
Redial