Filter
Top Products
REQUIREMENTS OF PART 68 - FCC RULES
This device has been granted a registration number by the Federal Communications Commission,
under Part 68 rules and regulations for direct connection to the telephone lines. In order to comply
with these FCC rules, the following instructions must be carefully read and applicable portions fol-
lowed completely:
1) Direct connection to the telephone lines may be made only through the standard modular cord
furnished, to the utility installed jack. No connection may be made to party or coin phone lines.
On the bottom of the phone is a label that contains, among other information, the FCC Registration
Number and the Ringer Equivalence number (REN) for this equipment. If requested this information
must be provided to the telephone company. The USOC Jack for this equipment is RJ11C.
2) The telephone company, under certain circumstances, may temporarily discontinue and make
changes in facilities and services which may affect the operation of the users' equipment. However,
the user shall be given adequate notice in writing to allow the user to maintain uninterrupted service.
3) In certain circumstances, it may be necessary for the telephone company to request information
from you concerning the equipment which you have connected to your telephone line. Upon request
of the telephone company, provide the FCC registration number and the ringer equivalence number
of the equipment which is connected to your line; this information will be found on the device.
4) If any of your telephone equipment is not operating properly, you should immediately remove it
from the telephone line. It may cause harm to the telephone network.
5) If the telephone company notes a problem, they may temporarily discontinue service. When practical,
they will notify you in advance of disconnection. If advance notice is not feasible, the telephone com-
pany must; promptly notify you of such temporary discontinuance; afford the opportunity to correct
the condition; inform you of your rights to bring a complaint to the FCC under their rules.
6) Repairs to the device may be made only by the manufacturer or an authorized service agency.
This applies at any time during and after warranty. If unauthorized repair is performed, registration,
connection to the telephone lines and remainder of warranty period all become null and void.
7) This equipment is hearing aid compatible.
REQUIREMENTS OF PART 15 - FCC RULES
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction,
may cause harmful interference to radio communications. However, there is not a guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
a) move the telephone away from the receiver. b) consult the dealer or an experienced radio/TV
technician for help. Any changes made by the user not approved by the manufacturer can void the
user's authorty to operate the telephone.
INDUSTRY OF CANADA REQUIREMENTS
NOTICE: The Industry Canada label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective operational and safety requirements
as prescribed in the appropriate Terminal Equipment Technical Requirements documents. The
department does not guarantee the equipment will operate to the users satisfaction. Before installing
this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of
connection. The customer should be aware that compliance with the above conditions may not pre-
vent degradation of service in some situations. Repairs to certified equipment should be coordinated
by a representative designated by the supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the telecommunications company cause to request
the user to disconnect the equipment. Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines, and internal metallic water pipe systems, if
present, are connected together. This precaustion may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority or electrician, as appropriate. The Ringer Equivalence
Number (REN) of this device is z.
NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indi-
cation of the maximum number of terminals allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of devices subject only to the requirement
that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. This
telephone connects to the telephone network under the connecting arrangement code CA11A.
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETYPRECAUTIONS SHOULD
ALWAYS BE FOLLOWED TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK AND INJURY
TO PERSONS, INCLUDING THE FOLLOWING:
1. READ AND UNDERSTAND ALL INSTRUCTIONS.
2. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE PRODUCT.
3. UNPLUG THE PRODUCT FROM THE WALL OUTLETBEFORE CLEANING. DO NOT USE
LIQUID CLEANER OR AEROSOL CLEANERS. USE A DAMP CLOTH FOR CLEANING.
4. DO NOT USE THIS PRODUCTNEAR WATER, FOR EXAMPLE: NEAR A BATHTUB, WASH
BOWL, KITCHEN SINK OR LAUNDRYTUB, IN A WET BASEMENT, OR NEAR ASWIMMING POOL.
5. DO NOT PLACE THIS PRODUCTON AN UNSTABLE CART, STAND OR TABLE. THE PROD-
UCT MAY FALL, CAUSING SERIOUS DAMAGE TO THE PRODUCT.
6. SLOTS AND OPENINGS IN THE CABINETAND THE BACK OF BOTTOM ARE PROVIDED
FOR VENTILATION. THESE OPENINGS MUST NOT BE BLOCKED OR COVERED. THE
OPENINGS SHOULD NEVER BE BLOCKED BY PLACING THE PRODUCTON ABED, SOFA,
RUG OR ANY OTHER SIMILAR SURFACE. THIS PRODUCT SHOULD NEVER BE PLACED
NEAR OR OVER A RADIATOR OR HEAT REGISTER. THIS PRODUCTSHOULD NOT BE
PLACED IN A BUILT-IN INSTALLATION UNLESS PROPER VENTILATION IS PROVIDED.
7. NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCTTHROUGH CABINET SLOTS
AS THEY MAYTOUCH DANGEROUS VOLTAGE POINTS OR CAUSE ASHORT CIRCUITTHAT
COULD RESULT IN A FIRE OR ELECTRIC SHOCK. NEVER SPILLLIQUID OF ANYKIND ON
THE PRODUCT.
8. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE THIS PRODUCT.
IF SERVICE IS NECESSARY, SEND OR TAKE THE TELEPHONE TO AQUALIFIED SERVICE
FACILITY. OPENING OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS VOLT-
AGES OR OTHER RISKS. INCORRECT REASSEMBLY CAN CAUSE ELECTRIC SHOCK
WHEN THE APPLIANCE IS SUBSEQUENTLY USED.
9. UNPLUG THIS PRODUCT FROM THE WALL OUTLETAND REFER SERVICING TO QUALI-
FIED SERVICE PERSONNELUNDER THE FOLLOWING CONDITIONS:
• IF THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED
• ID LIQUID HAS BEEN SPILLED INTO THE PRODUCT
• IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER
• IF THE PRODUCT DOES NOTOPERATE NORMALLYBY FOLLOWING THE
OPERATING INSTRUCTIONS. ADJUSTONLY THOSE CONTROLS THATARE
COVERED BY THE OPERATING INSTRUCTIONS, AS IMPROPER ADJUSTMENTOF
OTHER CONTROLS MAY RESULT IN DAMAGE AND WILL OFTEN REQUIRE
EXTENSIVE WORK BYAQUALIFED TECHNICIAN TO RESTORE THE PRODUCT TO
NORMAL OPERATION.
• IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS BEEN DAMAGED.
• IF THE PRODUCT EXHIBITS ADISTINCT CHANGE IN PERFORMANCE.
10. AVOID USING THE TELEPHONE DURING AN ELECTRICALSTORM. THERE MAY BE A
REMOTE RISK OF ELECTRIC SHOCK FROM LIGHTNING.
11. DO NOT USE THE TELEPHONE TO REPORTAGAS LEAK IN THE VICINITY OF THE
LEAK.
IF YOUR PRODUCT USES BATTERIES, FOLLOW THESE ADDITIONAL PRECAUTIONS:
1. USE ONLY THE TYPE AND SIZE OF THE BATTERY SPECIFIED.
2. DO NOT DISPOSE OF BATTERIES IN A FIRE. THE BATTERIES CAN OR MAY EXPLODE.
CHECK LOCAL CODES FOR PROPER BATTERYDISPOSAL INSTRUCTIONS.
Teledex, LLC
6311 San Ignacio Avenue
San Jose, CA 95119
Telephone: (408) 363-3100
Fax: (408) 363-3136
email: sales@teledex.com
Internet: www.teledex.com
Copyright © 2002 Teledex LLC
All Rights Reserved.
Part Number: 600-0480-59
MAIN DIAGRAM
RIGHT VIEW
LEFT VIEW
WALL MOUNTING
Handset Volume
Speaker Volume
Handset Coil Cord
Handset Jack
Data Port
Cord Channel
Wall Jack
FOR CUSTOMER SERVICE CALL
1-800-783-8353
Wall Mount Clip
(under handset)
Handset
Ringer Volume
Data Port
Line Jack
Handset Volume
Mute Key
Redial Key
Flash Key
Speaker Volume
Store Key (hidden)
Guest Service Keys
Dial Pad
Speakerphone Key Hold Key Message Waiting Indicator