Filter
Top Products
4
SPT 1500
3. Replace the battery door so that it is flush with the back of the
SPT 1500 and “clicks” into position.
Note: Do not force the battery door. When the batteries are
correctly installed, the battery door clips smoothly into
place. If you feel resistance when replacing the battery
door, make sure the door is aligned with the slots on the
back of your SPT 1500, and that the batteries are firmly
seated in the battery compartment.
W
ARNING
While batteries are being replaced, data is retained for ap-
proximately one minute. We strongly suggest that you have
your replacement batteries ready for insertion before remov-
ing the old batteries from the unit.
Starting the SPT 1500
Calibrating the Screen
The first time you start your SPT 1500, the calibration screen
automatically appears. Follow the steps in this section to align the
internal circuitry of your SPT 1500 with its touch-sensitive screen.
Note: If your SPT 1500 unit came pre-loaded with another
software application, you may not need to calibrate
your screen, and you will not see the calibration screen.